Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
This should not be necessary if the correct dosage of detergent is used. Information on the indicator lights model-dependent . Risk of electric shock. Disconnect the mains plug. . Risk of explosion. No solvents. 10 Maintenance Detergent solution pump Turn the programme selector to Off and disconnect the mains plug. 1. Open and remove the service flap. 2. For models with a drainage hose: Remove the drainage hose from the retainer and pull it from the housing. Remove the container. Remove the sealing cap, allow the detergent solution to flow out. Replace the sealing cap and place the drainage hose in the retainer. 2* For models without a drainage hose: Carefully unscrew the pump cover until the detergent solution begins to flow out. When the service flap is half full, close the pump cover and empty the service flap. Repeat the above steps until all the detergent solution has completely drained out. 3. Carefully unscrew the pump cover (residual water). 4. Clean the interior, pump cover thread and pump housing (the impeller in the detergent solution pump must rotate). 5. Replace the pump cover and screw it tightly in place. 6. Place the service flap back on and close. To prevent unused detergent from flowing straight into the drain during the next wash: pour 1 litre of water into compartment II and start the .. Drain programme. Drainage hose at the siphon Turn the programme selector to Off and disconnect the mains plug. 1. Loosen the hose clamp, carefully remove the drainage hose (residual water). 2. Clean the drainage hose and siphon connecting piece. 3. Reattach the drainage hose and secure the connection with the hose clamp. Filter in the water supply Risk of electric shock. Do not immerse the HydroSafe safety device in water (it contains an electric valve). Reduce the water pressure in the supply hose: 1. Turn off the tap. 2. Select any programme (except for ....Rinse/ ..Spin//..Drain). 3. Select ..Start/Pause. Let the programme run for approximately 40 seconds. 4. Turn the programme selector to Off. Disconnect the mains plug. Clean the filter: 1. Depending on model: Disconnect the hose from the tap. Clean the filter using a small brush. and/or for Standard and Aqua-Secure models: Remove the hose on the rear of the appliance. Remove the filter with pliers and clean. 2. Connect the hose and check for leaks. . Risk of scalding. Allow the detergent solution to cool down. . Turn off the tap. What to do if ... . Water is leaking out. . Attach/repl. Tighten the ace the drainage hose correctly. screw connection of the supply hose. . No water supply. Detergent not dispensed. . $ Start/P. Tap not tur. Filter block. Supply hosause not selected? ned on? ed? Clean the filter .> page 10. e kinked or trapped? . Washing machine door cannot be opened. . Safety func. Is Rinse Holtion active. Wait approx. 2 minutes. d (without final spin) selected? .> page 3, 4. . Programme does not start. . $ Start/Pause . Washing mselected? achine door closed? . Detergent solution is not drained. . Is Rinse Hol. Clean the d. Clean the wd (without final spin) selected? .> page 3, 4. etergent solution pump .> page 10. aste pipe and/or drainage hose. . Water not visible in the drum. . Not a fault -water below the visible area. . Spin result not satisfactory. . Distribute la. ....Easy Iro. Too low a srge and small items of laundry evenly in the drum. n selected? .> page 5. peed selected? .> page 5. . Spin cycle performed several times. . Not a fault imbalance. -unbalanced load detection system adjusts the . Residual water in the compartment for care products. . Not a fault . Clean the i-the action of the care product is not affected. nsert if necessary .> page 9. . Odour formation in the washing machine. . Run prograstandard detergent. mme ....Cottons 90 °C without laundry. Use . Foam escaping from the detergent drawer. . Too much If foam is eMix 1 tableinto compa. Reduce the detergent used? scaping from the detergent drawer: spoon of fabric softener with . litre of water and pour rtment II (not with outdoor or down fabrics). detergent dosage for the next wash cycle. . Intense noise formation, vibrations and .walking. during the spin cycle. . Are the appSecure the . TransportatRemove thinstructions. liance feet fixed? appliance feet .> Installation instructions. ion safety devices removed? e transportation safety devices .> Installation . The indicator lights do not function during operation. . Power cut? . Fuses tripp. If the fault oed? Reset/change the fuse. ccurs repeatedly, call the after-sales service. . Programme sequence longer than usual. . Not a fault imbalance . Not a fault rinse cycle. -unbalanced load detection system adjusts by repeatedly distributing the laundry. -foam detection system active -adds an additional . Detergent residues on the laundry. . Occasionalresidues. . Select ....Rly, phosphate-free detergents contain water-insoluble inse/ ..Spin or brush out the laundry after washing. If you cannot correct a fault yourself (s...