|
Facilidade de uso
Following the instructions on each label will help ensure the best laundry results. WASH BLEACH Machine Wash Cycle Normal Permanent Press/Wrinkle Resistant Gentle/ Delicate Hand wash Warning Signs Hot Warm Cold Do not wring Do not wash Bleach Symbols Any bleach (when needed) Warning Signs Only non-chlorine bleach (when needed) Do not bleach DRY DRYCLEAN Tumble Dry Cycle Warning Signs Dry Do not tumble dry Normal Permanent Press/Wrinklle Resistant Gentle/ Delicate High Medium Low No heat/Air Do not dry (used withDo not wash) Line dry/ Hang to dry In the shade Special Instructions Drip dry Dry flat Heat Setting Dryclean Warning Signs Dryclean Do not dryclean IRON Iron - Dry or SteamWarning Signs Iron High Medium Low Do not iron No steam -14 802716 Maintenance Lubrication Exhaust System All moving parts are sealed in a permanent supply of lubricant or are equipped with oilless bearings. Additional lubrication will not be necessary. Care of Your Dryer To reduce the risk of an electric shock, serious injury or death, disconnect the electrical service to the dryer before cleaning the interior. W132WA R N I N G Dryer Interior Wipe the surfaces using a soft cloth and household cleaner or a non-abrasive paste ofpowdered laundry detergent and hot water, followed by a short heat cycle with a load of rags. To remove crayon or ball point ink off the dryer drum, put the heat on high and use old rags in the dryer to absorb the crayon or ink. If unsuccessful, contact the appliance dealer. DO NOT use any chemicals in the dryer. IMPORTANT: The use of chlorine bleach for removing any discolorations should be avoided because bleach could damage the finish. Cabinet Wipe the dryer cabinet as needed. If detergent, bleach or other washing products have been spilled on the dryer, wipe immediately. Some products will cause permanent damage if spilledon the cabinet. WA R N I N G To reduce the risk of electric shock, disconnect the electrical service to the dryer before cleaning. W043 The exhaust duct should be inspected after one year of use and cleaned if necessary. Inspect and clean exhaust duct every one to two years asrequired thereafter. The weather hood should be checked frequently tomake sure the dampers move freely, dampers arenot pushed in and that nothing has been setagainst them. Keep dryer area clear and free from combustible materials, gasoline and other flammable vapors and liquids. Do not obstruct the flow of combustion and ventilation air. NOTE: Verify proper operation after servicing. Motor Overload Protector The dryer’s motor overload protector stops the motor automatically in the event of an overload. After cooling, the overload protector will reset itself. Dryer can be restarted by pushing the timer knob in. If overload protector cycles again, remove the dryer from use and call the serviceperson to correct the problem. Control Panel Use only a damp or sudsy cloth for cleaning thecontrol panel. Some spray pretreat products may harm the finish on the control panel. NOTE: The wiring diagram is located inside the control panel. -15 802716 -16- 802716 Lint Filter The lint filter is located at the front of the dryer in the lower part of the door opening. CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. Remove lint filter cover, clean lint filter and replace cover. Annually remove lint filter and screw to vacuum the duct under it. DRY2025N Troubleshooting Try these troubleshooting tips before making a service call – You may save time and money! Dryer Symptom Possible Cause/Solution Dryer won’t start • For dryers equipped with a power cord, make sure the power cord is plugged all the way into the electrical outlet. • Make sure loading door is closed. • Push timer knob in to start dryer. • Make sure the laundry room fuse(s) isn’t blown or loose, or circuit breakers aren’t open. The dryer itself does not have an electrical fuse. An electric dryer has an electrical...
Este manual também é adequado para os modelos :Secadores - DRY2024N (3.07 mb)
Secadores - DRY2029N (3.07 mb)
Secadores - DRY2030N (3.07 mb)
Secadores - DRY2031N (3.07 mb)