Failure to do this may result in serious personal injury. The Model G4176 power feeder is equipped with two sets of change gears that provide four different feed rates of 20, 26, 33, and 43 feet per minute. The Model H3236 Slow Speed Kit provides two additional feed rates of 13 and 62 feet per minute. Use the table below (Figure 1) and these instructions to install the required change gears to get your desired feed rate. Change Gear and Feed Rate Chart Model H3236 Slow Speed Kit Gears: A, 16

Adjust the trigger knob until there is no air escaping from the cleaning gun. 3. Connect the siphon hose to the cleaning gun and place the other end into an approved container of engine cleaning solution. shown). 4. To adjust the amount of solution being used, rotate the siphon knob; to adjust the amount of air flow; rotate the trigger knob. 5. Hold the gun so the nozzle is 6-10" from the surface and squeeze the trigger knob. 6. When you are done, place the siphon hose into a clean bucket o

The owner of this welder MUST maintain the original location and readability of the labels on the welder. If any label is removed or becomes unreadable, REPLACE that label before using the welder again. Contact Grizzly at (800) 523-4777 or to order new labels. -16- H8153 DC Stick/TIG Pulse Welder

When used on its side, you will want to adjust the rollers so the leading wheel is about 1/4" closer to the table than the trailing wheel. There are three important factors to consider when using the power feeder with a table saw; pinching, binding and blade height. If you are ripping boards 4" or wider, place the power feeder between the fence and blade with the rollers turned slightly toward the fence. If you are ripping materials less than 4", set the rollers as close as possible to the fence

—Threshold Limit Values (Booklet) -6 H8151 230V Mini Welder H8151 230V Mini Welder -7- SECTION 2: CIRCUIT REQUIREMENTS Circuit Requirements Amperage Draw The Model H8151 welder draws the following amps under maximum load: Draw at 220V ......................................... 24 Amps Circuit Requirements Connect your welder to a dedicated and grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing circuit with one of higher amperage without con

#TS9041 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

#TS9402 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

#LO9344 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................