#Cr10394 printEd in taiWan .........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

WaRNiNG: NO PORtiON OF tHiS MaNuaL May bE REPRODucED iN aNy SHaPE OR FORM WitHOut tHE WRittEN aPPROvaL OF GRizzLy iNDuStRiaL, iNc. #Cr10816 priNtEd iN taiWaN ......................................................................................................................................................................................................................................................................................................................................................

The reason for this order is that with the power feeder unit completely assembled, it will be easier to locate where on the table top you will need to drill your base mounting holes, so you can take advantage of the full range of power feeder swing and adjustments. Through-Bolt Mounting We recommend that you mount your new power feeder to the machine table with through bolts, nuts, and washers (Figure 9). This option will give the most rigidity and clamping strength to prevent the feeder base

#LO9344 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

#TS9402 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

#TS9041 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

—Threshold Limit Values (Booklet) -6 H8151 230V Mini Welder H8151 230V Mini Welder -7- SECTION 2: CIRCUIT REQUIREMENTS Circuit Requirements Amperage Draw The Model H8151 welder draws the following amps under maximum load: Draw at 220V ......................................... 24 Amps Circuit Requirements Connect your welder to a dedicated and grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing circuit with one of higher amperage without con

When used on its side, you will want to adjust the rollers so the leading wheel is about 1/4" closer to the table than the trailing wheel. There are three important factors to consider when using the power feeder with a table saw; pinching, binding and blade height. If you are ripping boards 4" or wider, place the power feeder between the fence and blade with the rollers turned slightly toward the fence. If you are ripping materials less than 4", set the rollers as close as possible to the fence