Assessments - 6, GPA: 3.3
(
)
)
|
Facilidade de uso
In particular, ensure your children do not hang over or destabilize the TV; doing so may cause the TV to tip over, causing serious injuries or death. Follow all safety precautions provided on the included Safety Flyer. For added stability, install the anti-fall device for safety purposes, as follows. ■ To avoid the TV from falling: 1. Put the screws into the clamps and firmly fasten them onto the wall. Confirm that the screws have been firmly installed onto the wall. N You may need additional material such as an anchor depending on the type of wall. N Since the necessary clamps, screws, and string are not supplied, please purchase these additionally. 2. Remove the screws from the centre back of the TV, put the screws into the clamps, and then fasten the screws onto the TV again. N Screws may not be supplied with the product. In this case, please purchase the screws of the following specifications. N Screw Specifications - For a 17 ~ 29 Inch LCD TV: M4 X 15 / For a 32 ~ 40 Inch LCD TV: M6 X 15 3. Connect the clamps fixed onto the TV and the clamps fixed onto the wall with a strong string and then tie the string tightly. N Install the TV near to the wall so that it does not fall backwards. N It is safe to connect the string so that the clamps fixed on the wall are equal to or lower than the clamps fixed on the TV. N Untie the string before moving the TV. 4. Verify all connections are properly secured. Periodically check connections for any sign of fatigue for failure. If you have any doubt about the security of your connections, contact a professional installer. English - 24 | Troubleshooting: Before Contacting Service Personnel No sound or picture • Check that the mains lead has been connected to a wall socket. • Check that you have pressed the button on your set. • Check the picture contrast and brightness settings. • Check the volume. Normal picture but no sound • Check the volume. • Check whether the MUTEM button has been pressed on the remote control. • Check the Speaker Select settings. Screen is black and power indicator light blinks steadily • On your computer check; Power, Signal Cable. • The TV is using its power management system. • Move the computer's mouse or press any key on the keyboard. No picture or black and white picture • Adjust the colour settings. • Check that the broadcast system selected is correct. Sound and picture interference • Try to identify the electrical appliance that is affecting the set and move it further away. • Plug your set into a different mains socket. Blurred or snowy picture, distorted sound • Check the direction, location and connections of your aerial. • This interference is often due to the use of an indoor aerial. Remote control malfunctions • Replace the remote control batteries. • Clean the upper edge of the remote control (transmission window). • Check the battery terminals. ‘Check signal cable.' message is displayed • Check that the signal cable is firmly connected to the PC or video sources. • Check that the PC or video sources are turned on. On PC mode, ‘Not Supported Mode.' message is displayed • Check the maximum resolution and the frequency of the video adaptor. • Compare these values with the data in the Display Modes. The damaged picture appears in the corner of the screen If Screen Fit is selected in some external devices, the damaged picture may appear in the corner of the screen. This symptom is caused by external devices, not TV. The ‘Resets all settings to the default values.' message appears. This appears when you press and hold the EXIT button for a while. The product settings are reset to the factory defaults. You may see small particles if you look closely at the edge of the bezel surrounding the TV screen. This is part of the product's design and is not a defect. N The TFT LCD panel uses a panel consisting of sub pixels (3 133 440) which require sophisticated technology to produce. However, there may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product. Model Name LE26B450C LE32B450C Screen Size (Diagonal) 26 inches 32 inches PC Resolution (Optimum) 1360 x 768 @ 60Hz 1360 x 768 @ 60Hz Sound (Output) 10W X 2 10W X 2 Dimensions (WxDxH) Body 670 x 75 x 455 mm 800 x 85 x 531 mm With stand 670 x 216 x 495 mm 800 x 252 x 577 mm Weight With Stand 8 kg 12 kg Environmental Considerations Operating Temperature 10°C to 40°C (50°F to 104°F) 10°C to 40°C (50°F to 104°F) Operating Humidity 10% to 80%, non-condensing 10% to 80%, non-condensing Storage Temperature -20°C to 45°C (-4°F to 113°F) -20°C to 45°C (-4°F to 113°F) Storage Humidity 5% to 95%, non-condensing 5% to 95%, non-condensing Stand Swivel Left / Right 0" -20" ~ 20" N Design and specifications are subject to change without prior notice. N This device is a Class B digital apparatus. N For the power supply and Power Consumption, refer to the label attached to the product. Eng...
Este manual também é adequado para os modelos :TV - LE32B450C (4.94 mb)
TV - LE26B450C4W (4.95 mb)
TV - LE32B450C4W (4.95 mb)