Assessments - 3, GPA: 4.3
(
)
)
|
Facilidade de uso
Keep away from areas of excessive heat or moisture. To insure optimum color purity do not position magnetic equipment (motors, fans, other speakers, etc.) nearby. Optional External Equipment Connections The Video/Audio connections between components can be made with shielded video and audio cables. For best performance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic supply house. Before you purchase any cables, be sure you know what type of output and input connectors your various components require. Also determine the length of cable you’ll need. Condensation When the set is moved into a warm room from a cold area, the picture may become out of focus because of condensation on the lens surface due to the temperature change. Picture will become clear when the set reaches the same temperature of the surrounding area. AC Power Supply Cord CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE THIS (POLARIZED) PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. FOR SOME MODELS THAT ARE NON-POLARIZED, THE USE OF AN AC ADAPTOR CONNECTOR MAY BE NECESSARY. Remote Control Battery Installation Batteries: Use two “AA” batteries. 1. Install the batteries as shown in the battery compartment. (Polarity {+) or (-) must be correct.) Helpful Hints: For frequent Remote Control users, replace old batteries with Alkaline batteries for longer life. CAUTION: Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control Transmitter. Observe the Following Precautions: 1. Batteries should be replaced as a pair. Always use new batteries. 2. Do not combine a used battery with a new one. 3. Do not mix battery types (Example: “Zinc Carbon” with “Alkaline”). 4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 5. Battery replacement is necessary when Remote Control reacts sporadically or stops operating the Receiver. Helpful Hints: Whenever you remove the batteries to replace them, you may need to reset the Remote Control Infrared Codes. -6- Installation (cont.) Antenna/CableConnections Antenna Connection - For proper reception of VHF/UHF channels, an external antenna is required. For best reception an outdoor antenna is recommended. Antenna Mode must be set to TV. (Refer to Antenna Mode section.) VHF/UHF on Back of Set Indoor Typical VHF/UHF Antenna 75 Ohm Incoming Cable from Home Antenna 300 Ohm n mam VHF/UHF on Back of Set or 300 to 75 ohm Matching Transformer (Not Included) Cable Connection - For reception of cable channels, connect the cable supplied by your local cable company. Antenna Mode must be set to CABLE. (Refer to Antenna Mode section.) Incoming Cable from Cable Company 75 Ohm VHF/UHF on Back of Set Note: Certain cable systems offset some channels to reduce interference or have Premium (scrambled) channels. A cable converter box is required for proper reception. Check with your local Cable company for compatibility requirements. Other Video Equipment VCRs, Video Disc Players, Computers, TV games, and DSS equipment can also be connected to the antenna input connection. -7- Optional Equipment Connection and Operation To Audio AMP Connection (Stereo) TERMINALS ON BACK OF RECEIVER M Lizt-pbI I * , o o »..jail S.,;-:.’.
TV - PT61G42 (1.51 mb)
TV - PT61G42C (1.51 mb)
TV - PT51G42C (1.51 mb)