Assessments - 3, GPA: 4.3
(
)
)
|
Facilidade de uso
Do not disassemble this product except when disposing of it. Danger As the rechargeable battery is specifically for this product, do not use it for any other device. Do not charge the removed battery. Do not throw the battery in a fire, or apply heat to it. Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it. Do not let the wires touch any other metal or each other. Do not carry or store the battery with a necklace, hair pin, or the like. Do not charge, use, or leave the battery in a hot location such as near a fire or under the hot sun. Doing so may cause the battery to generate heat, ignite, or rupture. ENGLISH (continued overleaf) Warning Warning ENGLISH Do not place the removed battery, screws, and other items within reach of infants. Accidental swallowing of such an item may have an adverse effect on the body. In the event that you think such an item has been swallowed, consult a doctor immediately. In the event of fluid leaking from the battery, take the following measure, and do not touch the fluid with bare hands. Fluid entering into an eye may cause loss of eyesight. Wash the eye with water immediately without rubbing it, and then consult a doctor. Fluid getting on your body or clothes may cause inflammation of the skin or injury. Sufficiently rinse with clean water, and then consult a doctor. ..How to remove the battery Disassemble this product after the battery has run out of power. The following figures are intended to explain how to dispose of the product, not for describing how to repair. The product cannot be repaired once it has been disassembled. 1. Remove the screws of the 3D Eyewear with a precision Phillips (plus ) screwdriver. 2. Bend the frame inwards and pull it off from the side cover. If it is difficult to pull off, insert a flat-blade (minus ) screwdriver and pry open it. 10 3. Pull off the battery and separate it from the 3D Eyewear by cutting off the wires, one by one, with scissors. Insulate the wire parts of the removed battery with cellophane tape. Battery NOTE • Take sufficient care when performing this work so as not to injure yourself. • Do not damage or dismantle the battery. ENGLISH 11 Troubleshooting/Q&A ENGLISH Check the followings first. If they do not solve the problem, please contact the place of purchase. Images are not 3D. > Is the 3D Eyewear mode set to 3D? Slide the tab once to the 3D/2D position to change the mode between 3D and 2D. > Are the image settings switched to 3D images? Refer the television operating instructions. > Is there a sticker or other such item blocking the infrared reception section on the 3D Eyewear? If the eyewear stops receiving infra-red signal from the television, the power automatically switches off after 5 minutes. > Individual differences may occur in which the 3D images are difficult to see, or cannot be seen, especially in users that have a different level of eyesight between the left and right eyes. Take the necessary steps (wearing glasses etc.) to correct your eyesight before use. The power of the 3D Eyewear turns off by itself. > Are there any objects between the eyewear and television? > Is there a sticker or other such item blocking the infrared reception section on the 3D Eyewear? If the eyewear stops receiving infra-red signal from the television, the power automatically switches off after 5 minutes. The indicator lamp does not light when the power switch is set to “ON”. > Is the 3D Eyewear sufficiently charged? If the indicator lamp does not light at all, the battery is completely flat. Perform the battery charging operation. 12 The battery does not charge, or operation time is short when charged. > Is the charging cable connected properly? Make sure the charging cable is properly connected. > Is the television power off? Switch the television power on, then charging will start. > The battery has reached the end of its lifespan. If operation time is very short even when the battery is charged, the battery has reached the end of its lifespan. Please consult with the place of purchase. ENGLISH 13 ENGLISH Specifications Usage temperature range 0 °C - 40 °C (32°F - 104°F) Charging power supply DC 5 V (supplied by USB terminal of a Panasonic TV) Battery Lithium-ion polymer rechargeable battery DC 3.7 V, 40 mAh Operation time*1: Approx. 25 hours Charging time*1: Approx. 30 minutes Quick charge (2 minutes charge enables approx. 3 hours use) Viewing range*2 Transmitter for 3D Eyewear Within 10.5' (3.2 m) from front surface (Within ± 35° horizontal, ± 20° vertical) Materials Main body: Resin Lens section: Liquid crystal glass Dimensions (not including nose pad part) Models TY-EW3D3LU TY-EW3D3MU TY-EW3D3SU Width 6.72" (170.6 mm) 6.61" (167.7 mm) 6.32" (160.5 mm) Height 1.67" (42.2 mm) 1.67" (42.2 mm) 1.67" (42.2 mm) Overall length 6.73" (170.7 mm) 6.73" (170.7 mm) 6.60" (167.6 mm) Mass Approx. 0.96 lb (Approx. 27 g) Approx. 0.92 lb (Approx. 26 g) Approx. 0.92 lb (Approx. 26 g) *1 Operation time/C...