Assessments - 4, GPA: 4.3 ( )

Fabricante : Toshiba Arquivo Tamanho: 5.46 mb Arquivo Nome : Língua de Ensino:

• PC IN connection allows you to use the TV as a computer monitor. • Two HDMI digital, High-Definition Multimedia Interface connections. • Two sets of ColorStream® HD high-resolution component video inputs. • Dolby* Digital and SRS WOW™ audio technologies. • Digital Audio Out optical audio connection. • CableClear® picture noise reduction. * Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories. 3X70701A_En_p02-09 7 3/7/06, 6:23 PM 8 Connecting your TV Selecting a location for the TV • Place the TV on the floor or on a sturdy platform in a location where light does not directly hit the screen. • Place the TV far enough from the walls to allow proper ventilation. Inadequate ventilation may cause overheating, which may damage the TV. Connecting your TV If you haven’t connected electronic equipment before, or you have been frustrated in the past, you may wish to read this section. (Cables are not supplied.) • A coaxial cable is the standard cable that comes in from your antenna or cable converter box. Coaxial cables use “F” connectors. • Standard A/V (audio/video) cables are usually color coded according to use: yellow for video and red and white for audio. The red audio cable is for the stereo right channel, and the white audio cable is for the stereo left (or mono) channel. If you look at the rear panel of the TV, you will see that the terminals are color coded in the same manner as the cables. • S-video cables provide better picture performance than standard video cables. S-video cables can only be used with S-video compatible components. • Component video cables provide better picture performance than Svideo cables. Component video cables can only be used with component video compatible components. • HDMI (High Definition Multimedia Interface) cable is for use with video equipment that has HDMI output (see page 14.) ColorStream HD 2 IN Back of TV Right back panel OPTICAL AUDIO OUT HDMI-2 IN VIDEO-2 IN RF IN PC IN HDMI-1 IN AC INLET VIDEO-1 IN ColorStream HD-1 IN COAXIAL AUDIO OUT AUDIO/VIDEO OUT IR OUT Left back panel Exploring your new TV (continued) ANTENNA Coaxial Cable AUDIO Cables VIDEO Cable Coaxial Cable Component video Cables HDMI Cable Optical Cable IR blaster Cable S-Video Cable NOTE: DO NOT CONNECT A PC USING ONE OF THE HDMI INPUTS. ALWAYS use the VGA port provided to connect a PC. • IR blaster cable is for use with video device with IR (infrared) remote control. • Optical/Coaxial cable is for use with AV amplifier with built-in digital surround (Dolby Digital or PCM.) 3X70701A_En_p02-09 8 3/7/06, 6:23 PM 9 Introduction TV Setting up your TV Using the TV’s Features Appendix Connecting a cable converter box or antenna This television has an extended tuning range and can tune most cable channels without using a cable company supplied converter box. Some cable companies offer "premium pay channels" in which the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device, which is generally provided by the cable company. Option 1: For Subscribers to Basic Cable TV Service For basic cable service not requiring a Converter/Descrambler box, connect the incoming 75 ohm Coaxial Cable directly to the Antenna Jack on the back of the television. Option 2: For Subscribers to Scrambled Cable TV Service If you subscribe to a cable service that requires the use of a Converter/Descrambler box, connect the incoming cable to the Converter/Descrambler box and connect the output of the box to the Antenna Jack on the back of the television. Follow the connections shown below. Set the television to the output of the Converter/Descrambler box (usually channel 3 or 4) and use the Converter/Descrambler box to select channels. Option 3: For Subscribers to Unscrambled Basic Cable with Scrambled Premium Channels If you subscribe to a cable service in which basic cable channels are unscrambled and premium channels require the use of a Converter/Descrambler box, you may wish to use a two-set signal splitter (sometimes called a "two-set coupler") and an A/B Switch box from the cable installer or an electronics supply store. Follow the connections shown below. With the switch in the "B" position, you can directly tune any nonscrambled channels on your TV. With the switch in the "A" position, tune your TV to the output of the Converter/Descrambler box (usually channel 3 or 4) and use the box to tune scrambled channels. Note: When you use a converter box with your TV, there may be features that you cannot program using the remote control, such as labeling channels, blocking channels, and programming your favorite channels. From Cable Cable Box A B Cable Box Splitter A / B Switch Option 1: Option 2: Option 3: TV back panel Connecting your You will need: • two coaxial cables • one set of standard A/V cables Note: If using a mono VCR, connect L/Mono to VCR Audio OUT using only one audio cable. For bett...

Baixe o seu

Para fazer o download, introduza 2 dígitos :