Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
& Press the Select key repeatedly until no LED is lit. e To program DVD-R,press the OK key + digit 2. To program SAT (RC6),press the OK key + digit 4. To program CD-R,press the OK key + digit 6. From now on, when the corresponding (DVD, SAT, CD) indicator is selected, the remote control will operate your DVD-R, SAT (RC6) or CD-R. Note: To return to the modes programmed in the factor y, either remove the batteries for a few minutes, or press the OK key + digit 1 (DVD mode); or + digit 3 (SAT-RC5) or + digit 5 (CD mode). Tips Care of the screen Clean the TV with a slightly damp soft cloth. Do not use abrasive solvent as it can damage the TV screen. Poor Picture •Have you selected the correct TV system in the manual installation menu? • Is your TV or house aerial located too close to loudspeakers, non-earthed audio equipment or neon lights, etc.? • Mountains or high buildings can cause double pictures or ghost images. Sometimes you can improve the picture quality by changing the direction of the aerial. • Is the picture or teletext unrecognisable? Check if you have entered the correct frequency. See Installation, p. 6. •Are brightness, sharpness and contrast out of adjustment? Select Factory settings in the Setup, General menu, p. 8. • Sometimes poor picture quality is possible when having activated an S-VHS camera or camcorder connected to the right side of your TV and another peripheral is connected to one of the externals at the same time. In this case switch off one of the other peripherals. Digital distortion The low quality of some digital picture material may be the cause of digital image distortion. In this case select the Soft setting using the Picture menu, Smart Picture, without changing the picture settings manually. No picture • Is the aerial connected properly? •Are the plugs tightly connected in the aerial socket? • Is the aerial cable in good condition and does it have suitable plugs? No sound • No sound on any channel? Check the volume isn’t at minimum. • Is the sound interrupted with the mute key ¬? Check if your speaker configuration corresponds with the selections made in the Setup menu, Speakers, p. 7. • No sound from the connected audio receiver? Select Centre input Off in the Source menu, see p. 9. No Surround •Perhaps the channel is not broadcasting good quality surround sound. sound • No sound from the rear speakers or the centre speakers? Select an appropriate surround mode, according to the broadcasted sound signal or adjust the volume. See Surround Modes, p. 12. No solution found Switch your TV off and then on again once. Never attempt to repair a defective for your picture or TV yourself. Check with your dealer or call a TV technician. sound problem ? Menu Have you selected the wrong menu? Press the MENU I key again to exit from the menu. NEXTVIEW No NEXTVIEW info: See Acquisition and updating of NEXTVIEW information, p. 16. Displayed time is wrong: The broadcaster on programme number one does not transmit the correct local date and time. Use Reshuffle in the installation menu to place another broadcaster on programme number one. Remote control • If your TV no longer responds to the remote control, the batteries may be dead. • Check if the remote control is in the correct mode. •You can still use the M key and the -/+ keys at the top of your TV. Standby Your TV consumes energy in the standby mode. Energy consumption contributes to air and water pollution. Power consumption: 1,1 W. Inhaltsverzeichnis Einstellung Hilfe ? Falls Sie in der Bedienungsanleitung keine Antworten auf Ihre Fragen finden sollten, oder die genannten ‘Nutzliche Hinweise’ Ihre Probleme nicht losen, dann konnen Sie beim ortlichen Philips Info- oder Ser vice Center anrufen. Siehe dazu auch die beiliegende World-Wide Guarantee Broschure. Bitte halten Sie die Produktbezeichnung und Modellnummer bereit - welche Sie an der Ruckwand des Fernsehgerates oder an der Verpackung finden bevor Sie bei der Hotline anrufen. Model: 32PW9768 Product No: ............................................. Vorbereitung ..................................................................................... 2 Die Tasten oben am Fernsehgerat ............................................... 2 Ihre Fernbedienung ...................................................................... 3-4 Benutzung der Menus ..................................................................... 5 Wahl der Menusprache und des Landes .................................... 5 Speichern der Fernsehsender ....................................................... 6 Automatische Einstellung ........................................................ 6 Manuelle Einstellung ................................................................. 6 Namen geben ............................................................................ 6 Umprogrammieren ................................................................... 7 Vorzugsprogramme wahlen ................................................