Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
By saving energy, your thermostat will pay for If you require further assistance, call Hunter Technical Support itself during its first season of use. Thank you at 901-745-9222 from 8 a.m. to 5 p.m. Central Time. Hunter product! Model Information: 44550 Model Number ____________________________________ Serial Number _____________________________________ Date Purchased____________________________________ Where Purchased___________________________________________________________ Table of Contents 4- 5 INTRODUCTION Read This Before Installing Thermostat 6 Features INSTALLATION What You Need Remove Old Thermostat Wire Labeling Mount Wallplate and Thermostat Selector Switches PROGRAMMING Setting Time and Day Auto Programming Personal Program Schedule Manual Programming Weekday / Weekend Programming 7-Day Programming Reviewing Programs Reviewing the Current Temperature Setting OPERATIONS System Selector Switch Fan Switch (continued) Table of Contents (continued) OPERATIONS ( continued) Temporary Manual Override Permanent Manual (Vacation) Override Auto Season Changeover Home Today Energy Monitor Filter Monitor Auto Recovery Keyboard Lock Backlighting SAFETY FEATURES Low Battery Warning Error Mode Auto Cut-Off TROUBLESHOOTING Problems & Solutions Technical Support WIRING DIAGRAMS Heat / Cool Systems Single-Stage Heat Pump Systems Heat Only / Cool Only Systems Read This Before Installing Thermostat IMPORTANT 1 1 Read the entire installation section of this Owner’s Manual thoroughly before you begin to install or operate your Hunter Thermostat. REMOVE THE MYLAR LABEL FROM THE LCD WINDOW. INSTALLATION 2 2 All installation is normally performed at your thermostat. ARMCHAIR PROGRAMMING 3 3 You can program your thermostat before installation by inserting the batteries and following the instructions starting on page 16. This can be done while you relax in your favorite chair and is a very good way to familiarize yourself with all the functions of your Hunter Thermostat. Note: At initial power-up this thermostat is programmed at 68°F (20°C) for Heat and 78°F (26°C) for Cool. Any change to the set temperature will be treated as a Permanent Manual Override. See page 25 for more information. Press Auto Program to load the built-in energy saving programs. OPERATION 4 4 Your Thermostat is designed to operate with most gas, oil, electric or 2-wire hot water heating and air conditioning systems. It will also operate single-stage heat pumps that do not have auxiliary or emergency heat. These have 24-volt or millivolt control systems and represent most central heating, air or space heating units in use in the United This Hunter Thermostat will NOT control multi-stage heat pumps or 110/220 Volt systems. COMPRESSOR PROTECTION 5 5 The thermostat provides a 3.5 minute delay after shutting off the heating or cooling system before it can be restarted. This feature will prevent damage to your compressor caused by rapid cycling. Note that this delay also applies to the heating system control. It does not provide a delay when there are power outages. TEMPERATURE RANGE 6 6 Your thermostat can be programmed between 40°F and 95°F (4°C and 35°C). However, it will display room temperatures from 32°F to 99°F (0°C and 37°C). “HI” will be displayed if the temperature is higher than 99°F (37°C), and “LO” will be displayed if the temperature is lower than 32°F (0°C). NOTE: The thermostat will automatically change to the Cool mode if the thermostat measures a temperature over 99°F (37°C). “Hi” will be displayed on the LCD, and the Cooling system will turn On. Similarly, the thermostat will automatically change to the Heat mode if the temperature is below 32°F (0°C). “LO” will be displayed on the LCD, and the Heating system will turn On. Read This Before Installing Thermostat (continued) POWER FAILURE 7 7 Whenever the main power is interrupted battery power retains the programs and current time. AUTO RECOVERY 8 8 Your thermostat is set from the factory to gradually recover the room temperature from an energy saving program to your comfort program. Therefore, the thermostat may turn your system on several minutes prior to your programmed time. This operation is normal, but can be turned off. Refer to the Selector Switches information on pages 14-15. BATTERY WARNING 9 9 Fresh alkaline batteries should provide over one year of service. However, when the batteries become drained, “BATT” will alternate on the display with the current time. When this message occurs, install 2 new AA batteries. You have approximately 1 minute to change keep thermostat’s clock and program settings. Once the batteries have become too low to proper operation, your system will be turned Off, and the display will be cleared except for “BATT” flashing on the LCD display. ! CAUTION: Once the “BATT” only display occurs, the thermostat is shut down, and your system will no longer operate. In this condition, there is no temperature control your dwelling. NOTE: The INDIGLO ® night-ligh...
Este manual também é adequado para os modelos :Os termostatos - 44550 (303.1 kb)
Os termostatos - 44550 (303.1 kb)