Assessments - 3, GPA: 3.3
(
)
)
|
Facilidade de uso
Then route the cable under a pulley mounted on the plate welded on the rear Base Frame (1), attach Pulley Guard (28) and Metal Tab (27) at both side of the pulley, using one 3/8" X 2" Hex Bolt (117) and one 3/8" Nylon Nut (138). 4. Route the cable up and around pulley mounted in the second hole in the bottom of the Double Pulley Block (24), using one 3/8" X 1-3/4" Hex Bolt (118) and one 3/8" Nylon Nut (138). When cabling is complete, this pulley can be moved upward to take a slack or downward to gain length. 5. Continue to route the cable down to the pulley on the Base Frame (1), mount a pulley using one 3/8" X 1-3/4" Hex Bolt (118) and one 3/8" Nylon Nut (138) as shown in Fig.6. 6. Continue to route the cable underneath the weight stack and around the horizontally mounted pulley on the Leg Press Main Frame (202), mount the pulley using one 3/8" X 1-3/4" Hex Bolt (233) and one 3/8" Nylon Nut (241) as shown in Fig. 7. 7. Continue to route the cable through the slot in the Leg Press Main Frame (202), and under and around (exiting on the top) the lowest pulley on the Rear Leg Press Support (208) as shown in Fig. 8,10. Mount the pulley using one 3/8" X 1-3/4" Hex Bolt (233) and one 3/8" Nylon Nut (241). 8. Then route the cable under and around (exiting on the top) the right side (as if sitting on seat) pulley mounted in the leg Press Main Frame (202) as shown in Fig.9,11. Mount two pulleys here using one 3/8" X 2-3/4" Hex Bolt (232) and one 3/8" Nylon Nut (241). 9. Route the cable in the same manner under and around the uppermost pulley mounted on the Rear Leg Press Support (208) as shown in Step 1. Mount the pulley using one 3/8" X 1-3/4" Hex Bolt (233) and one 3/8" Nylon Nut (241). 10. Route the cable in the same manner under and around the left side (as if sitting on seat) pulley mounted in the Leg Press Main Frame (202) as shown in Step 2. 11. Hold the ball end of the cable with Metal Washer (246) in front of the inner tube of the receptor holder (244). Tighten the receptor Holder (244) on the Rear Leg Press Support (208) as shown in Fig.12, using one 3/8" X 2-1/4" Hex Bolt (249), two 3/8" Washers (238) and one 3/8" Nylon Nut (241). -6- -7-...