Assessments - 3, GPA: 5 ( )

Fabricante : Sears Arquivo Tamanho: 324.03 kb Arquivo Nome : 16ea0dab-aa5d-495c-b752-3cc4504ab842.pdf Língua de Ensino:

1. Refer to the inset drawing. Remove the indicated plastic cap from the Frame (1). Discard the cap. Next, slide the bracket on the Rear Stabilizer (2) into the Frame (1). Attach the Rear Stabilizer with four Stabilizer Screws (32). 2. Align the Front Stabilizer (5) with the saddle bracket on the front of the Frame (1). Make sure that the Front Stabilizer is turned so the square holes are facing away from the saddle bracket. Attach the Front Stabilizer with two Stabilizer Carriage Bolts (18), two Curved Washers (14), and two Stabilizer Nuts (30). 3. Refer to the inset drawing. Remove the indicated plastic caps from the Frame (1). Discard the caps. Next, slide the Left Handlebar (40) into the left side of the Frame (1). Slide the Right Handlebar (41) into the right side of the Frame. Slide the Foam Grip (42) onto the Top Handlebar (3). Push the ends of the Foam Grip towards the center of the Top Handlebar so the ends of the Top Handlebar are uncovered. Insert the Top Handlebar into the Left and Right Handlebars (40, 41) and attach it with two Handlebar Screws (33). Slide the Foam Grip back so it covers the Handlebar Screws. Align the holes in the Left and Right Handlebars (40, 41) with the holes in the Frame (1). Attach the Handlebars with four Handlebar Bolts (36), four Handlebar Washers (38), and four Locknuts (37). Make sure that the Locknuts are in the hexagonal holes in the Frame. 2 5 14 1 30 18Square Holes 2 1 32 3 40 37 36 38 1 38 33 33 41 3 42 1 1Cap 1 Caps 4 4. The Console (7) requires two "AA" batteries (not included). Alkaline batteries are recommended. Refer to the inset drawing. Remove the battery door from the back of the Console. Press two batteries into the battery compartment. Make sure that the negative ends of the batteries (marked O.O) are touching the springs in the battery compartment. Re-attach the battery door. Next, plug the console wire into the socket on the back of the Console (7). Slide the Console (7) onto the console plate. Note: The Console attaches by friction; it does not snap into place. 5. Attach the Seat (11) to the Seat Post (10) with three Seat Nuts (9) and three Seat Washers (8). Note: The Seat Nuts and Seat Washers may be pre- attached to the underside of the Seat. Insert the Seat Post (10) into the Frame (1). Press the Frame Bushing (4) into the Frame. Note: The Frame Bushing may be pre-assembled. Next, align one of the holes in the Seat Post (10) with the hole in the Frame (1). Insert the Seat Pin (31) through the Frame and the Seat Post to select the desired seat height. Make sure to insert the Seat Pin through one of the holes in the Seat Post; do not insert the Seat Pin under the Seat Post. Tighten the Seat Pin into the Frame. 6. Identify the Right Pedal (22). (The Right Pedal is marked with an OR.O) Using an adjustable wrench, tighten the Right Pedal clockwise into the right arm of the Crank (20). Tighten the Left Pedal (21) counterclockwise into the left arm on the Crank (20). 4 Battery Door Batterie...

Baixe o seu

Para fazer o download, introduza 2 dígitos :