Assessments - 5, GPA: 3.6
(
)
)
|
Facilidade de uso
Never operate lantern without heat shield. ¦ Take lantern outdoors away from ignition sources. ¦ Turn fuel valve off. (Fig. 7) ¦ Remove protective cap from top of propane cylinder. Save cap for use in storing. (Fig. 8) ¦ Note: Use Coleman 16.4 oz. disposable propane cylinders. The LP-gas cylinder(s) used with lanterns must be constructed and marked in accordance with the specifications for LP-gas cylinders of the U.S. Department of Transportation or Transport Canada, CAN/CSA B339. Fig. 7 Fig. 8 DANGER • EXPLOSION - FIRE HAZARD • Propane is heavier than air and can accumulate in low places. If you smell gas, leave the area immediately. • Always attach or detach propane source outdoors; never while lantern is lighted, near flame, pilot lights, other ignition sources or while lantern is hot to touch. • Always light & use lantern outdoors. • This lantern must not be exposed to flammable vapors or liquids during lighting. • This lantern is red hot during use and can ignite flammables too close to the mantles. Keep flammables at least 12 inches from the sides and 48 inches from the top of the lantern. Keep gasoline and other flammable liquids and vapors well away from lantern. ¦ Screw propane cylinder into lantern. Take care not to cross-thread. Hand tighten only. (Fig. 10) ¦ Set lantern into base. (Fig. 11) Fig. 10 Fig. 11 Ball Nut Fig. 5 ¦ Always extend base before use. (Fig. 9) Fig. 9 Reflector ¦ Always use genuine Coleman® #21 size mantles. If using Insta-Clip® II tabbed mantles, follow the instructions on the mantle package. ¦ If using tie style mantles, tie mantles around grooves in burner. (Fig. 1) ¦ Distribute folds on mantle evenly. Cut off surplus string 1/4" (0.6cm) from knot. (Fig. 2) ¦ For INSTASTART™ electronic ignition lanterns, be careful that mantle does not snag on electrode. English-4 ¦ Push lighted match through lighting hole, hold near mantle and open fuel valve fully. (Fig. 15) Match Light Lantern INSTASTART™ Electronic Ignition Lantern CAUTION • SERVICE SAFETY • Keep all connections and fittings clean. Inspect propane cylinder and lantern propane connections for damage before attaching. • During set up, check all connections and fittings for leaks using soapy water. Bubbles indicate a leak. Never use a flame. Fig. 15 Fig.16 ¦ Open burner valve and repeatedly push igniter button and ignite the mantles. (Fig. 16) WARNING • BURN HAZARD • Never leave lantern unattended when hot or in use. • Keep out of reach of children. NOTE: If lantern does not light, repeat above step. If the lantern does not light after several attempts, check for a spark while clicking the igniter. If no spark is present, check the electrode gap. The gap should be about .2" (5 mm). Carefully bend electrode to set gap. If the lantern is wet due to rain, high humidity, etc., the electrode may not spark. Use lighting procedure for match light version lanterns. (Fig. 17) ¦ Brightness may be adjusted with fuel valve. (Fig. 18) Fig. 18 To Turn Off ¦ Make sure lantern is cool. ¦ Move lantern away from flame (including pilot lights) and other ignition sources. ¦ Remove propane cylinder from lantern. (Fig. 20) ¦ Replace protective cap on propane cylinder. ¦ Turn fuel valve off. (Fig. 19) Fig. 20 To Store Fig. 19 DANGER • EXPLOSION - FIRE HAZARD • Never store propane near high heat, open flames, pilot lights, direct sunlight, other ignition sources or where temperatures exceed 120 degrees F (49°C). • The cylinder must be disconnected when the lantern is in storage. ¦ Lantern can be placed in base for secure storage. (Fig. 21) Fig. 21 Fig. 13 Fig. 14 ¦ Reflecting position. Bottom tab rests inside lantern frame. (Fig. 13) ¦ Storage position. Reflector hangs from back rails. (Fig. 14) .2" (5 mm) Fig. 17 ¦ Assemble reflector to back of lantern. Position the reflector clips onto the center of the two back rails and slide either upward into the reflecting position or downward into the storage position. (Fig. 12) Fig. 12 Things You Should Know Warranty 1. It is unsafe and illegal in some places to store or use liquid propane cylinders of greater than 1.14 kg (2.5 lbs.) water capacity (approximately 465g [1 lb.] propane) in occupied enclosures. 2. Always have a spare set of Coleman® Mantles. Once burned, a mantle is fragile and can be damaged if touched or dropped. 3. Wipe lantern clean with soft cloth and mild dish detergent. Do not use abrasives. 4. The usual storage areas for camping and picnic equipment are the basement, attic, or garage. To avoid the accumulation of dust, cobwebs, etc., that is common in these storage areas, place your lantern in a plastic bag and seal it with a rubber band. 5. During operation, carry the lantern using the bail. 6. If your lantern burns with a yellow smokey flame, check the burner and air tube for spider webs. 7. For repair service call one of the numbers listed on the front cover for location of your nearest Coleman Service Center. If lantern must be mailed to Service Center, attach to the product a t...