Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
4.
Remove all cabling from the rear of the enclosure. Ensure all cabling
is marked to facilitate re-cabling later.
WARNING!
A disk enclosure fully populated is heavy. Prior to
removing the enclosure from the rack, remove each
disk and label it with its bay number. Place each disk
on a clean surface. If this is not possible, two people
are required to remove the enclosure from the rack to
prevent injury.
5.
Remove hard drives from the enclosure.
Press the release button on the drive lever (1), and rotate the lever
to the left (2).
Then, pull the disk drive out of the drive bays (3), leaving it in the
enclosure.
1. Fan 1 interconnect
2. Fan 2 interconnect
board
board
Figure 1 Fan interconnect board locations
Verifying component failure
6.
Loosen the thumbscrews that secure the enclosure to the front of the
Before replacing the module, check the following and confirm with HP
rack, and remove the enclosure from the rack.
support that it has failed:
7.
Remove the top access cover.
• Analyze any failure messages received. HP fault monitoring software
provides a recommended action.
a.
Lift the access panel latch (1). The access panel will slightly
• Check the fan module status LED.
disengage from the enclosure.
Table 1 Fan module status LED descriptions
b.
Slide the access panel to the rear (2) and lift away from the
chassis.
LED status
Description
Off
No AC power
Green—blink-
Healthy, no fault conditions detected
ing
Green—solid
The module is being identified
Amber—blink-
Error, problems detecting the module.
ing
Amber—solid
Error, fault conditions detected
NOTE:
A Torx tool with T-10 and T-15 ends is provided inside
Removing a fan interconnect board
the enclosure chassis, on top of the I/O module
housing.
1.
Schedule a maintenance window.
2.
Stop all I/O to the enclosure.
3.
Power down the enclosure by pressing and holding the On/Standby
button on the rear of disk enclosure, until the system power LED
changes from green to amber.
Page 2
... Este manual também é adequado para os modelos :
dados de dispositivos de processamento - HP D2600 Disk Enclosure/S-Buy (269.46 kb)
dados de dispositivos de processamento - HP D2600 w/6 2TB 6G SAS 7.2K LFF DP MDL HDD 12TB Bundle (269.46 kb)
dados de dispositivos de processamento - HP D2600 w/6 3TB 6G SAS 7.2K LFF Dual port MDL HDD 18TB Bundle (269.46 kb)
dados de dispositivos de processamento - HP D2600 w/6 450GB 6G SAS 15K LFF Dual Port Enterprise HDD 2.7TB Bundle (269.46 kb)