Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
2. While moving the bat ery mounting latch (2, Figure 2 ) to the right,
CAUTION:
pull the battery out of the enclosure (3). Support the battery with
If Command View EVA does not present a status consistent
both hands as it is removed.
with that of the battery status indicator, or if Command View or
the System Event Analyzer indicates multiple hardware failures,
contact HP support for assistance. The HP support web site is
located at ht p://www.hp.com/support
• Analyze any failure messages you may have received from system
monitoring (System Event Analyzer).
• Check status using Command View EVA:
3
2
CAUTION:
1
If you are running HP StorageWorks Command View EVA
0180a
4.0, the battery numbering presented in the management
interface is inconsistent with the numbering used in the storage
Figure 2 Removing a battery
system and reported by the ISEE/WEBES monitoring tool. HP
Command View EVA 4.0 identifies the top bat ery as 1 and
the bot om bat ery as 2. The correct numbering should be 0
and 1 respectively. Remember to make this conversion when
Installing a battery
replacing a battery. This inconsistency is corrected in later
• Position the battery as high in the slot as possible, then slide the
versions of HP Command View EVA.
battery into the enclosure (1, Figure 3) until it is ful y seated and
the mounting latch engages (2).
1. In the Navigation pane, select Storage system > Hardware >
Rack > Controller enclosure > Controller
2. In the Content pane, select the Enclosure tab. The status is
displayed in the Cache Battery Modules field. The status should
be Failed
3. To help identify the correct enclosure, click Locate > Locate On
to display Locate Confirmed on the controller operator
control panel (OCP). The blue Unit ID indicator will also turn on.
• Check the battery status indicators. See Figure 1. The bat ery fault
1
indicator should be on. To view the status indicators it is necessary
2
to remove the front panel as described in Removing a bat ery.
0179a
Figure 3 Installing a battery
Verifying proper operation
After replacing the battery, check the following to verify that the
component is operating properly:
NOTE:
It may take up to 10 minutes for the component to display
good status.
• Check the bat ery status indicators. See Figure 1
• During the first minute, both status indicators may be on or
flashing.
• The status indicator (1) should then begin flashing, indicating
Figure 1 Battery status indicators
the battery is charging. It may take several hours for a new
battery to fully charge. The fault indicator (2) should be off
1. Status indicator
during charging.
2. Fault indicator
After checking the status indicator, install the front panel on the
enclosure by pressing it firmly into place.
3. Bat ery 0
• From Command View EVA
4. Bat ery 1
• Navigate back to the component and check the status. It should
be
• Turn off the locate function by clicking Locate > Locate Off
Removing a bat ery
1. Remove the front panel (1, Figure 2) by grasping the panel at each
end pulling it off the enclosure.
Page 2
... Este manual também é adequado para os modelos :
dados de dispositivos de processamento - HP EVA4000/6000/8000 Disk Arrays (123.63 kb)
dados de dispositivos de processamento - HP StorageWorks EVA4000 SAN Starter Kit (123.63 kb)
dados de dispositivos de processamento - HP StorageWorks EVA4000 Starter Bundle (123.63 kb)