Assessments - , GPA:
(
)
)
Fabricante : HP
Arquivo Tamanho: 341.98 kb
Arquivo Nome :
Língua de Ensino: 
O documento está colocado, por favor, espere
 |
O documento está colocado, por favor, espere
por este dispositivo também tem outras instruções :
Facilidade de uso
Removing a drive bay cover
Preparing to install the tape drive
1.
Identify the location for the tape drive. If this is
the first tape drive, install it in the bottom drive
Removing a tape drive
bay. Otherwise, install the new drive in the next
higher drive location.
If you are replacing a tape drive:
Most MSL tape libraries have half-height drive
•
Make sure the tape cartridge has been removed
connectors in all drive locations. The MSL8048
from the tape drive. Use the operator control
and MSL8096 libraries only have drive
panel (OCP) or the remote management interface
connectors in the full-height drive locations. For
(RMI) to move the cartridge to a storage slot or
these libraries, leave a half-height space above
mailslot.
each half-height drive, as shown.
•
If you are replacing the tape drive in a single
drive unit or the master drive in a multi-drive unit,
verify that backups are not occurring on the drive
you are replacing. If backups are occurring on
the master drive, verify that the library will not be
accessed through this drive while the drive is
being replaced.
1.
Use the OCP or RMI to power off the tape drive.
2.
Verify that the tape drive LED is off, and then
remove the SAS cable from the tape drive.
IMPORTANT:
If you install a new drive
between two existing tape drives, the drive
numbering might change. In this case, you
may need to reconfigure your backup
software.
2.
Using a Phillips screwdriver, remove the drive bay
cover.
3.
Loosen the blue captive thumbscrews on the tape
drive. Pull straight back on the tape drive handle
while supporting the bottom of the drive to remove
it from the unit.
2
1
1
1
2
CAUTION:
Support the bottom of the tape
drive when removing it to avoid damaging
any of the internal connections.
Page 2
... Este manual também é adequado para os modelos :
dados de dispositivos de processamento - HP MSL Tape Library (341.98 kb)
dados de dispositivos de processamento - HP MSL2024 0-Drive Tape Library (341.98 kb)
dados de dispositivos de processamento - HP MSL2024 1 LTO-4 Ultrium 1760 SAS Tape Library (341.98 kb)
dados de dispositivos de processamento - HP MSL2024 1 LTO-4 Ultrium 1840 Fibre Channel Tape Library (341.98 kb)