Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
The ironer remains idle. Subsequently put the main switch to position 0. WARNINGS AND ADVICE Prior to carrying out any inspection or work on the ironer, make sure that it is disconnected from the mains power supply. The fundamental part to operation of all the models is a heating element (ironing plate). Avoid deliberate contact with points which in normal working position (hands resting on the table) cannot be reached. The noise level produced by our range of ironers is less than 70 dB. When the ironer is used for the first time the insulation on the heating elements emits a peculiar smell for a few minutes. This is normal and should not alarm the user. It is advisable to begin by ironing lightweight items which require a lower temperature and go on to heavier items, gradually raising the temperature by means of the thermostat control. When the ironer is in operation the roller covering absorbs a certain amount of humidity. For this reason at the end of the ironing session it is advisable to let the roller turn for a couple of minutes. This will help to evaporate residual humidity and keep longer the roller covering in good condition. When the machine is turned off, make sure that the roller and the ironing plate are not in contact. Temperatures above 140/150°C will increase production but will also scorch the items or the roller covering. During the washing cycle prior to ironing, the use of suitably softened water is recommended in order to prevent scale building up on the ironing surface, which would dirty the linen. A suitable amount of washing powder is also recommended in order to avoid deposits which cause friction between the product and the ironing surfaces. In the event of a power failure, avoid accidental scorching by raising the ironing plate. This can be done manually. Turn off the main switch and open the door on the right side using the relative key. The handwheel is situated under the ironing plate motor, to be found behind the right-hand panel of the ironer, should be turned counterclockwise (see fig. 3) to move the ironing plate away from the roller. Take the time to check the exact position of the handwheel as soon as you receive your ironer. The operator carrying out this procedure should have first turned off the differential switch fitted between the mains outlet and the machine. The roller surface must be correctly utilised (see fig. 3) in order to keep the surface even over the whole circumference of the roller and to obtain optimum temperature distribution. In this way scorching of the ironed product and a drop in hourly machine production are both avoided. SAFETY DEVICES FINGER GUARD -The finger guard (A) prevents the operator's hands being exposed to the heated ironing plate. By exerting minimum pressure on the bar, the ironing plate is raised from the roller. To begin ironing again, press the switch START and press the pedal. EMERGENCY STOP BUTTON -The ironing plate can be raised from the roller by pressing the red "mushroom shaped knob" (P). To disconnect the knob, turn in the direction of the arrows. To begin ironing again, press the switch START and press the pedal. MAIN SWITCH (B) -Prevents contact with live electric circuits. LOW VOLTAGE CONTROLS -All the controls on all models are connected to low voltage, 24 Volts. MANUAL IRONING PLATE CONTROL -In t...
Este manual também é adequado para os modelos :Irons - RI1400/25 AVL (654.41 kb)
Irons - RI1400/25 F (654.41 kb)