Assessments - 2, GPA: 3.5 ( )

Fabricante : DCS Arquivo Tamanho: 110.53 kb Arquivo Nome : Língua de Ensino:

3 B -Cooking Instructions B -Cooking Instructions Automatic start-up without valves Turn the corresponding knob anti-clockwise up to the maximum position (large flame, Fig. 1) and press start-up button P(fig. 1). Automatic start-up with valves Turn the corresponding knob anticlockwise up to the maximum position (large flame, fig. 1) and press the knob. Once the burner has been started up, keep the knob pressed for about 6 seconds. Using the burners In order to obtain the maximum yield without wasting gas, it is important that the diameter of the pot is suitable for the burner potential (see the following table). This is to avoid the flame extremities being larger than the base of the pot. All of the operating positions must be chosen between the maximum and the minimum ones, never between the minimum position and the closing point. The gas supply can be interrupted by turning the knob clockwise up to the closing position. NOTE: If there is no power supply, it is possible to light the burners with matches, setting the knob to the startup point (large flame, fig. 1). NOTE: When the equipment is switch off, always check that the knobs are in the closing position. If the flame should blow out accidentally, the safety valve will automatically stop the gas supply, after a few seconds. To restore operation, set the knob to the lighting point (large flame, fig. 1) and press. While cooking with fat or oil, pay the utmost attention as these substances can catch fire when overheated. WARNING: – Do not use sprays near the appliance in operation. – Do not place unstable or deformed pots on the burner, so as to prevent them from overturning or overflowing. – Always turn gas off if moving a pot away from the appliance. BURNERS POWER (MJ/h) POWER (Btu/h) O of pots Auxiliary 3.2 3000 10 - 14 cm Semi-rapid 6.3 6000 16 - 18 cm Rapid 11.6 11000 20 - 22 cm Wok 17.9 17000 24 - 26 cm 4 C -Cleaning C -Cleaning WARNING: – Before any operation, disconnect the appliance from the electric grid. – Do not clean the appliance while it is hot. Enameled Burner Caps The enameled burner caps must be washed with a sponge and soapy water or with a light detergent. WARNING: – Do not use abrasive or corrosive products. – Do not leave substances, such as lemon or tomato juice, salt water, vinegar, coffee and milk on the enameled surfaces for a long time. Stainless Steel The stainless steel parts should also be cleaned with soapy water and then dried with a soft cloth. WARNING: – Stainless steel can be stained if it remains in contact with highly calcareous water or aggressive detergents for an extended period of time. – Stainless Steel can also discolour if in contact with excessive heat. Burners and racks These parts can be removed to make cleaning easier. The burners must be washed with a sponge and soapy water or with a light detergent, wiped well and placed in their housing perfectly. After cleaning, check that the feeler of the safety valve, start-up electrode and the flame-dividi...

Baixe o seu

Para fazer o download, introduza 2 dígitos :