Assessments - 2, GPA: 3.5
(
)
)
|
Facilidade de uso
Call a qualified technician to repair the appliance. 9. Do not store flammable materials near hot components or let grease or other flammable substances accumulate on the cooktop. Getting Started Before operating the cooktop, clean the glass ceramic surface carefully as outlined in the Care and Cleaning Instructions. The cooktop surface must be free of any foreign substances, especially those that could melt and permanently adhere to the glass. During the first uses of your new cooktop, you may smell a slight burning odor or see light smoke. Both of these conditions are normal in new glass ceramic cooktops. Heating Elements DACOR glass ceramic cooktops contain ribbon type radiant heating elements in various sizes to allow the user the greatest cooking flexibility. The Ribbon Radiant Heaters illuminate within approximately 3-4 seconds of activation. The Dual Element consists of two elements which may be operated simultaneously for heavy cooking demands. The inner element may be operated alone for improved simmering with smaller utensils. All elements feature temperature limiters to ensure that the safe operating temperature of the glass ceramic top is never exceeded. DACOR glass ceramic cooktops operate by automatically cycling the heating elements between “off” and full power. As the numeric setting of the control is increased, the element will stay at full power for longer periods and at zero power for shorter durations. When the element is set to the dual range, both the inner and outer elements will cycle on and off at the same time. (The outer heating element can never be operated alone.) For maximum performance from any burner remember to closely match heating element diameters and cookware size. Residual Heat Indicator Lights All Dacor glass cooktops have element residual heat indicator lights. These indicating lights remain illuminated until the burner cools down to a safe temperature of 140. degrees. IMPORTANT: Be certain that the cookware and glass surfaces are clean and dry before you turn on the burner and place a pot or pan on the heating burner. Element ON Indicator Light One light indicating power is on to any of the elements. Setting the Controls NOTE: When at its highest setting, the heating element may cycle off due to the protection of the temperature limiter built into each element. This temperature limiting occurs automatically to prevent exceeding the maximum allowable surface temperature and to maintain the constant desired heat level. The element will cycle back on after it has cooled to a safe temperature. ETT Models To turn an element on, tap the “ON/OFF” key then tap the up arrow for the desired element. The element will come on at a setting of “5” and may be adjusted up or down by pressing the appropriate key. To activate the Dual Element, tap the “ON/OFF” key then tap the Dual Element Indicator to activate the outer ring of the element. It will come on at a setting of “5”, then tap the up indicator for desired temperature setting. To turn an element off, tap the “ON/OFF” key. You may turn off all active elements at the same time by tapping twice on the Dacor logo located below the controls. ETT Secure Lockout To avoid accidentally turning the cooktop on while cleaning it, activate the “Secure Lockout” feature. To lock out the cooktop: Press and hold the DACOR logo for 3-4 seconds and the cooktop will be secured from use. You will hear three beeps and a light will illuminate directly above the DACOR logo indicating that the cooktop is secure. The control panel is now disabled and may be cleaned without activating any functions. To unlock the cooktop: Press and hold the DACOR logo for 3-4 seconds. You will hear three beeps and the light will go out. The control panel is now ready for use. NOTES: 1. For maximum safety, the cooktop will be in the “lock out” mode when first installed, or whenever power is interrupted. Follow the “Unlock” instructions above to reactivate the control panel. 2. To turn off multiple burners all at one time - tap the Dacor logo twice. 61/2" 1200W73/4" 1800W51/2" 1000W7" 1500W93/4" 2400W 7" 1500w73/4" 1800w9" 2100w61/2" 1200w93/4" 2400w51/2" 1000w Model ETT365 Top View Model ETT304 Top View CER 304 Model Push down and turn the knob to the desired temperature setting. The control knobs can be turned either clockwise or counterclockwise to the desired temperature setting. The knob that controls the Dual Element may be pushed down and turned counter-clockwise to heat the single inner element or clockwise to heat both the inner and outer elements. All knobs may be positioned below setting #1 to achieve the lowest temperatures possible. OFF121110987654321OFF121110987654321OFF121110987654321OFF121110987654321OFF1211109876543216" 1500W7" 1800W800W7" 1800W51/2" 1200W51/2" 1000W9" 2400W OFF121110987654321OFF121110987654321OFF121110987654321OFF1211109876543217" 1800W51/2" 1000W51/2" 1000W71/2" 2000W9" 2200W Figure 7: Model CERB365 Top View Model CER304 Top View NOTE:...
Este manual também é adequado para os modelos :Hobs - CER304 (337.63 kb)
Hobs - ETT304 (337.63 kb)
Hobs - ETT365 (337.63 kb)