Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
If the temperature of the place of installation falls lower than +18.C, it is necessary to turn on the freezing switch. A red light will be visible (Figure s/22). On carrying out this operation, the interior light will stay on at reduced power and in this way the necessary temperature will be maintained inside the freezer compartment for long-term food storage. In the event that the appliance is used for other purposes its conformity to the norms in force relating to the corresponding sector of activity must be guaranteed. In the same way, comply with the norms regarding accident prevention for refrigerating installations (VGB 20). The refrigerating circuit has been tested for leaks. The appliance has been manufactured according to the safety norms laid down for refrigerating appliances. All repairs must be carried out by qualified personnel. All repairs carried out by unqualified personnel can cause serious risks to the user. EN Getting to know the appliance Before starting to read, please open out the pages containing the photographs at the back of this booklet. This Instructions Manual applies to various models. It is possible therefore that some of the details shown on the photographs do not correspond exactly to your particular model. Parts of the appliance Figure a 2 Temperature selection control and interior light. 3 Storage shelves 4 Rear wall of the appliance (chilling) 5 Drainage duct 6 Drainage outlet 7 Glass shelf 8 Vegetable drawers 9 Egg tray 11 Butter container 12 Rack 13 Bottle rack 14 Freezing drawers 15 Chart showing storage periods for frozen products. 16 Ventilation grills 22 Switch (Fig s) A Refrigerator compartment B Freezer compartment Installing the Appliance Location for installation The most appropriate place for installing the appliance is in a dry, easily ventilated room. Avoid placing the appliance in a position where it is exposed to direct sunlight or close to a source of heat, eg. electric oven or cooker, radiator, stove etc. If it is unavoidable that the appliance is installed near a source of heat, fit suitable insulation or respect the minumum distances set out below: 3 cm between the appliance and an electric cooker. 30 cm between the appliance and oil- or coalfired ranges or ovens. If the appliance is to be installed next to another refrigerating unit, ensure that there is a minimum distance of 2 cm between them in order to avoid the formation of condensation. Installing the appliance and Changing the Opening Direction of the door Please see the Installation and Modifications Manual Electrical connection The appliance must only be connected to an alternating current of 220-240 V/50Hz. Ensure that the base of the plug socket is installed in accordance with the norms in force and fit a 10 amp fuse or automatic cut-off switch. Ventilation Ensure that the hot air emitted from the rear of the appliance may escape freely. This avoids the condenser having to work harder and prevents excessive electricity consumption. Therefore, ensure that the ventilation grilles are not obstructed in any way, and never cover them. EN Connection and temperature selection Clean the interior of the appliance thoroughly before using it for the first time. (See Cleaning). Connection Turn the temperature selector (Figure s) which is set at the “0” position. This will initiate refrigeration process. Observations: When the appliance is operating, drops of water or a layer of frost from on the rear wall of the appliance. This is normal. The appliance will automatically eliminate these and it is not necessary to scrape the frost off or dry the drops of water. The water is channelled along the drainage duct (Figure K/5) and is collected in a tray at the back of the appliance where it is evaporated. When the freezer compartment door is closed a vacuum is produced inside; wait two or three minutes before reopening it in order to allow it to depressurize. Temperature selection Use the temperature selector (Figure s) to regulate the temperature inside the refrigerator and freezer compartments according to the room temperature. The high numbers correspond to low degrees of temperature. When the temperature selector is at position “0”, the refrigeration process is turned off. This process will be initiated when the selector is turned to position “1”. An intermediate temperature position is recommended (approximately “2-3”). To freeze food, turn the temperature selector to position ~ “3” (see Freezing). Important for storing frozen foods If the temperature of the place in which the appliance is to be installed is lower than +18.C, it is necessary to turn on the switch. The red light will be visible. (Figure s/22). When this operation is carried out, the interior light will stay on at reduced power and in this way the necessary temperature will be maintained inside the freezer compartment for the long-term food storage. EN Disconnection and Disuse Disconnecting the...
Este manual também é adequado para os modelos :Hobs - CK267301/02 (428.53 kb)
Hobs - CK267301/03 (428.53 kb)
Hobs - CK267301/05 (428.53 kb)