Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
2. At this point we mark the top holes for securing the heater, as shown in figure 3. Drill the holes O 6x30. Insert the wall plugs and attach the top supports. Hang the appliance and after levelling it up, tighten these supports securely. Next, position the bottom support at the back of one of the central slots, mark the holes, drill them, insert the wall plugs and secure the support. Models ET9754 ET9854 ET9756 ET9856 ET9758 ET9858 ET9762 ET9862 N. modules 4 6 8 12 A 160 320 480 800 B 331 491 651 971 5. ELECTRIC CONNECTION UFESA appliances must be wired up correctly to ensure that they operate satisfactorily. First of all we need to have an electric supply that corresponds with the voltage stated on the appliance and which complies with all current legislation, there must also be sufficient power to be able to connect all of the appliances. The mains electricity supply for the panel heater must be fitted with a single-pole switch with contact gap of at least 3 mm Several appliances can be protected by a single common differential circuit breaker but always remember that the sum of the currents for all the electrical appliances, regardless of type, connected to the circuit breaker at the same time must never exceed its maximum capacity. For this purpose, and for the gauge of wire needed, the table below states the current that corresponds to the power rating and nominal voltages: 500 W 2.2 A 1000 W 4.3 A 750 W 3.3 A 1500 W 6.5 A Do not switch the appliance on if the cable or plug are damaged or if it can be detected that the appliance is not working correctly Should the mains cable become worn it will have to be replaced by a qualified specialist. Possible ledge Wall or nearest object on the right. Wall or nearest object on the left. 150 mm minimum 150 mm minimum 100mm minimum 250 mm minimum (Control panel side) 6. DESCRIPTION, NAMES & FUNCTIONS OF THE CONTROLS 6.1. ELECTRONIC TECHNO-DRY (ET9754-ET9756-ET9758-ET9762) 6.2 DIGITAL DRY (ET9854-ET9856-ET9858-ET9862) Function selector [ ] Comfort. Set temperature [ ] Economy and Night 3.5°C less than the set temperature [ ] Frost protect setting. [ ] Infrared pro gram operation [OFF] Standby. Fully off (*) The time and day of the week functions will only become visible on the LCD screen after the first transmission from the infrared control unit DEFINITION OF TERMS Frost protect position [ ]. Whenever we are away from the house on holidays, weekends or any other reason, a sharp drop in temperature can freeze pipes, plants, etc. In such cases the [ ] function can be used to keep the temperature between +5.C and +7.C approx. with very little power consumption. Comfort [ ] / Economy [ ] position: The [ ] selection drops the set temperature by 3.5.C, which means that we can use this option during the night and then bring it back up to the set temperature by selecting the [ ] option. It can also be used when we are not at home, keeping the house warm but using less electricity. 7. SWITCHING ON 7.1 ELECTRO...
Este manual também é adequado para os modelos :Hobs - ET9754/01 (1.21 mb)
Hobs - ET9756(00) (1.21 mb)
Hobs - ET9756/01 (1.21 mb)
Hobs - ET9758(00) (1.21 mb)