Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
Gas wok Control knob The markings show the setting between high and low heat. The flame setting is infinitely variable between high and low. . . . Special accessories You can order the following special accessories from your specialist dealer: VD 201 014 stainless steel appliance cover VD 201 034 aluminium appliance cover VV 200 014 stainless steel connection strip for combination with further Vario appliances VV 200 034 aluminium connection strip for combination with further Vario appliances WP 400 001 multi-layer material wok pan, with curved base and handle, O 36 cm, 6 litres volume, 10 cm high. Only use the accessories as specified. The manufacturer accepts no liability if these accessories are used incorrectly. Note: If the appliance cover VD 201 has been fitted, reverse the pot grid after it has cooled down before closing the cover. 8 Wok burner assembly Always assemble the burner par ts correctly and evenly to avoid faults during ignition or during use. When assembling the burner parts, make sure that the burner head is placed on the base in such a way that the heat sensor is positioned in the opening on the burner head. The catching pin on the burner ring must fit in the corresponding groove on the burner head. Operating principle The wok burner features three flame rings. Pressing down the control knob activates the ignition. The flame setting is infinitely variable between high and low. Op er at ion The markings on the control knob show the setting between high and low heat. The flame setting is infinitely variable between high and low heat. Notes . Only light a burner if all pan supports and burner parts are properly assembled. . Make sure the burners and ignition sparkers are clean and dry. . Fully press down the control knob and keep it pressed, then turn it to the required position. . After igniting, keep the control knob pressed for around 2 to 4 seconds more. The thermal sensor which controls the gas flow must be heated before the knob can be released. . If the flame should not ignite within 2 to 4 seconds, turn the control knob further to the left to the low heat position and then back to the high heat position after ignition. It is often faster to ignite the burner in the low heat position because the various gases have a differing ignition response. . Only use the recommended accessories. Do not cover the stainless steel cooktop base (e. g. with aluminium foil) . Switching on automatically Your cooktop features ignition sparkers for automatic ignition. 1 Place a suitable pot or pan on the corresponding cooking position. 2 Fully press down the corresponding control knob and turn it anticlockwise to the required position. The burner lights automatically. 3 Keep the control knob pressed for a few seconds after ignition. The flame size can be set continuously between high and low by slowly turning the control knob. Switching on manually During a power cut you can ignite the burners manually. 1 Place a suitable pot or pan on the chosen burner. 2 Press the corresponding control knob and turn it anticlockwise to the required setting. Keep the c...
Este manual também é adequado para os modelos :Hobs - VG231114/45 (1.62 mb)
Hobs - VG231134/01 (1.62 mb)
Hobs - VG231134/45 (1.62 mb)
Hobs - VG231214/01 (1.62 mb)