Assessments - , GPA: ( )

Instruções de Operação Delta Electronics, Modelo MCH 660

Fabricante : Delta Electronics
Arquivo Tamanho: 692.4 kb
Arquivo Nome : 68618f00-e047-47ff-b830-204caad4c9fd.pdf

Língua de Ensino:

O documento está colocado, por favor, espere

Baixe o seu Fechar

O documento está colocado, por favor, espere

Baixe o seu Fechar

Technical Information DIMENSIONS HEIGHT: 150mm WIDTH: 598mm DEPTH: 498mm DEPTH WITH VISOR OPEN: 510mm WEIGHT GROSS: 8,5 kg NET: 7,4 kg ELECTRICAL SUPPLY: Voltage (50Hz) 220-240 V POWER CONSUMPTION: 115W FAN MOTOR: 75W LAMP: 40W SUITABLE FOR INSTALLATION ABOVE: ELECTRIC HOB: 7KW (max) GAS HOB: 10KW (max) SLOT-IN GAS COOKER 13.5KW (max) SLOT-IN ELECTRIC COOKER 12.4KW (max) Note: CE Marking certifies that this appliance complies with the requirements laid down in EEC directive 89:336. (Electromagnetic compatibility) and subsequent modifications and Low Voltage directive 72/23/E. ELECTRICAL CONNECTIONS WARNING: DOUBLE INSULATED-DO NOT EARTH Electrical Requirements Any permanent electrical installation must comply with the latest I.E.E. Regulations and local Electricity Board regulations. For your own safety this should be undertaken by a qualified electrician e.g. your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC). Electrical Connection Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the cooker hood. This appliance is fitted with a 2 core mains cable and must be permanently connected to the electricity supply via a double-pole switch having 3mm minimum contact gap on each pole. A Switched Fuse Connection Unit to BS.1363 Part 4, fitted with a 3 A fuse is a recommended mains supply connection accessory to ensure compliance with the Safety Requirements applicable to fixed wiring instructions. This appliance conforms to BS.800: 1988 and EEC Directive No. 78 308 regarding suppression of radio and television interference. 10 INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood. Installation Requirements Before installation check the wall to which the cooker hood is to be fitted for electric cables, water or gas pipes. If it is necessary to fix the hood to a hollow construction plaster or partition board structure then it should be sufficiently reinforced to be quite rigid in the area of the cooker hood keyhole fixing screws, and the appropriate rawl plugs used for this type of fixing (not supplied). Ducting The ducting must be fire retardant 100mm (4ins) in diameter and the length should be no more than: 3 metres with one 90° bend 2 metres with two 90° bends Bends of more than 90° will reduce the efficiency of the hood and reduce the airflow. Clearance Height The cooker hood is designed to be fitted over a cooking appliance at the clearance heights stated, providing the maximum output of the appliance beneath does not exceed the maximums quoted in the Technical Specifications. If the output of the appliance below the cooker hood exceeds the maximum output quoted, please refer to the cooker hood manufacturer’s installation instructions. 11 Clearance Height A minimum clearance height of 650mm (25 1/2 ”) is required when installed above a built-in electric hob, o...