Assessments - 3, GPA: 3.7
(
)
)
|
Facilidade de uso
S,O) to the sides of the cooker hood corresponding to the drill holes specified for the screws. Fasten the cooker hood with 4 screws (Fig. S,P), place the connection ring and discharge pipe (or deflector if supplied) to the cooker hood outlet (see “Use” section), mount the lower bracket (Fig. S,Q) to the cooker hood with two screws and plastic washers (Fig. 6,T). Affixing the cooker hood to the wall use the drill holes diagram NI, drill as indicated, insert two hooks in the upper drill holes (Fig.6,R1) and two dowels in the lower drill holes (Fig.6,R2), fasten the lower bracket to the wall with two screws (Fig.6,Q), hang the cooker hood on the wall, regulate the position of the cooker hood (Fig.6 - screws SI for vertical regulation, screws S2 for depth regulation), place connection ring and discharge pipe (or deflector if supplied) to the cooker hood outlet (see “Use” section), fasten the cooker hood to the lower bracket (Fig.6,Q) with two screws and plastic washers (Fig. 6,T). Access to the screws that secure the lower bracket may be through the drill holes located inside the cooker hood (Fig.6,U). Electrical connection: The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Connect the electrical plug, where provided, to the an easily accessible outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from the contacts. Caution: This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Do not use the cooker hood where the grill is not correctly fixed! The suctioned air must not be conveyed in the same channel used for fumes discharged by appliances powered by other than electricity. The environment must always be adequately aerated when the cooker hood and other appliances powered by other than electricity are used at the same time. Flambé cooking with a cooker hood is prohibited. The use of a free flame is damaging to the filters and may cause fire accidents, therefore free flame cooking must be avoided. Frying of foods must be kept under close control in order to avoid overheated oil catching fire. Carry out fumes discharging in accordance with the regulations in force by local laws for safety and technical restrictions. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol ^ on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Operation The control panel is provided with a suction power selection switch and cook top light switch. Located on the side of the lamp panel. Warning! Some models are provided with automatic on/off switch via opening and closing the vapour collector. Use the higher suction speed for higher concentration of cooking vapours. It is recommended to operate the cooker hood suction S minutes prior to cooking and leave it in operation for approximately IS minutes after cooking. Maintenance Prior to any maintenance operation ensure that the cooker hood is disconnected from the electrical outlet. Anti-grease Filter Traps cooking grease particles. If situated inside the grill support, it may be one of the following types: Paper filter must be replaced once a month or sooner, if coloured on the upper side, when the coloration is visible through the grill holes. Sponge filter should be washed in soapy water monthly and replaced every S/6 washes. Metallic filter must be cleaned once a month by hand using non abrasive detergents or in dishwasher on low temperature and short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. To access the grease filter (Fig. 7,V) open the suction grill via the releases (Fig.2,H1) and loosen from locks (Fig. 7,W). Some models are provided with anti-grease filter incorporated in the suction grill, these should be removed from the housing by pulling the handles upwards and sliding out (Fig.2,H2-H3-H4), wash these filters as with metallic filters. Carbon ...