Assessments - , GPA:
(
)
)
Fabricante : Fujioh
Arquivo Tamanho: 359.85 kb
Arquivo Nome : BUF-06E_(1U03_1182).pdf
Língua de Ensino: 
O documento está colocado, por favor, espere
 |
O documento está colocado, por favor, espere
Facilidade de uso
There are three hazard classifications based on potentially dangerous situations. Obey all safety instructions that show these symbols to avoid possible injury, death and property damage. SAFETY INSTRUCTIONS WARNING: WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. CAUTION: CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. NOTE: The safety instructions are explained with the following pictographic symbols. means forcible execution. It indicates actions, if any, that must be done. WARNING 1. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a) Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. b) Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. CAUTION INSTALLATION 1. Preparation 2. Range Hood Mounting 3 Check that the top of the exhaust port is inserted into the bottom of 10" round duct, then make the duct joint secure and air tight using non-flammable tape such as duct tape, etc. (not supplied) 3. Connecting Power Supply Wires 1 Remove the nut from the conduit connector at the end of power wiring. 2 Remove two screws fixing the wire cover and detach it. 4. Final Assembly and Check 3. Read specification label on this product for further information and requirements. 2. To reduce the risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. 6. Fasten the filter and other parts securely. Incorrect attachment may result in personal injury or property damage. 4. Use only for the purpose of kitchen ventilation. 1. For general ventilating use only. Do not use to exhaust hazardous or explosive material and vapors. 5. Do not install this range hood in the bathroom or in other wet rooms since electrical shock and damage may result. 2. To reduce the risk of fire or electric shock, do not use this product with any solid-state speed control device. 4. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a) Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. b) Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s guidelines and safety standards such as those published by the National Fire Protection Association (NFPA), and The American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities. c) When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. d) Ducted fans must always be vented to the outdoors. e) The end user is responsible to ensure compliance with all Federal, State and Local Environmental and Fire codes. 1 According to the conditions where the range hood is installed, determine whether it will be discharged vertically or horizontally (10" Round duct). For vertical or horizontal discharge, run duct work between the hood location and the exterior blower used with the range hood. For best result in either direction, use a minimum number of transitions and elbows. As for installing the exterior blower, please refer to its installation. 2 The range hood unit must be mounted to a liner which has the following dimensions. Install the liner securely after checking that the opening size of the liner is the same as the figure below. • If the range hood is not installed properly, it could become detached and fall. • Ensure that the metal duct does not touch other metal housing materials, otherwise fire or electric shock could result. • When the liner is installed in the wooden hood, the inside of the wooden hood placed above the cooking surface must be fully covered by the metal barrier including bottom edges. Select a suitable liner and metal barrier according to the size and shape of the wooden hood and install properly. • The liner should be installed tightly. If the liner installation is not correct, the range hood unit may become detached and fall. • Wear working gloves to avoid injury. • To prevent air or moisture from entering through the wall opening, be sure to install wall insulation to seal around duct work completely. CAUTION: 5. Explanation to the End User (1) Referring to the Operation Manual, explain the operation of this range hood to end users. (2) The Installation Manual and Operation Manual should be given to the end user. 1 ...