Assessments - 5, GPA: 4.4
(
)
)
|
Facilidade de uso
When upper and lower chimney sections are in final position, attach the top of the upper chimney and the bottom of the lower chimney to the top and bottom brackets. 9. Align the “T” area of the canopy hood slots with the lower bracket flanges. Push hood toward wall. Gently lower the hood making sure the lower bracket flanges are fully inserted into the slots. Check that the hood is secure on the lower bracket. Feed enough power supply cable through conduit connector to make electrical connections. 10. Level the hood and adjust hood height by turning the adjusting screws. Check operation 16. Place filters in canopy openings so rear edge is over flange. Press filters up into position. 17. Turn power on. control panel location 18. The canopy hood controls are located in a grey panel on underside of the canopy. To open the panel, press on the front edge of panel and release. The control panel will drop down. light switch blower switch blower speed switch 19. Check the operation of the range hood: . Move light switch to “1” position. The light should turn on. . Move blower switch to “1” position. The blower should operate. . Move the blower speed switch to the far left; blower speed should be LOW. Move blower speed to right; blower speed should gradually increase until you reach HIGH speed at far right. . Move blower and light switches to “0” position to turn blower and light off. If range hood does not operate: . Check that the circuit breaker is not tripped or the house fuse blown. . Disconnect power supply. Check that wiring is correct. To get the most efficient use from your new range hood, read the “Use and Care Information” section. Keep your KitchenAid Installation Instructions and Use and Care Guide close to range hood for easy reference. Use and Care Information WARNING — TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock switch power off at service panel and lock service panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device such as a tag to the service panel. CAUTION: For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. WARNING — TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings. Always turn hood ON when cooking at high heat or when cooking flaming foods. Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter. Use proper pan size. Always use cookware appropriate for the size of the surface element. WARNING — TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: SMOTHER FLAMES with a close- fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. NEVER PICK UP A FLAMING PAN —You may be burned. DO NOT USE WATER, including wet dishcloths or towels — a violent steam explosion will result. Use an extinguisher ONLY if: You know you have a Class ABC extinguisher, and you already know how to operate it. The fire is small and contained in the area where it is started. The fire department is being called. You can fight the fire with your back to an exit. This fan suitable for use with solid- state speed controls. Operation The canopy hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen. control panel location Opening the canopy hood control panel: The hood controls are located in a grey panel on the underside of the canopy. To open the panel, press on the front edge of panel and release. The control panel will drop down. light switch blower switch blower speed switch Operating the light: ON: Move the light switch to the “1” position. OFF: Move the light switch to the “0” position. Operating the blower: ON: Move the blower switch to the “1” position. OFF: Move the blower switch to the “0” position. Adjusting the blower speed: The blower has variable speed control. Move the switch to the far left for LOW speed and to the far right for HIGH speed. Closing the range hood controlpanel: Push up on the front edge of the control panel. The control panel will slide up into the canopy. Cleaning Filters: The filters should be washed frequently. Place metal filters in dishwasher or hot detergent solution to clean. Exterior surfaces: Clean the range hood with a mild detergent and soft cloth. Do Not use...
Este manual também é adequado para os modelos :Fans - 30 (318.33 kb)
Fans - 48 (318.33 kb)