Assessments - 1, GPA: 3
(
)
)
|
Facilidade de uso
b) Use a small bladed screwdriver to prise off the light cover. c) Use a cloth to remove the bulb. Do not touch the bulb with fingers. d) Replace with a new bulb using a cloth. Do not touch the bulb with fingers. “Snap” the cover back in place. e) Halogen bulb 12Volt/20Watt required. 104735 issue E ECN: 04 101 For other accessories, parts or service, please contact your local supplier(Refer to the Warranty Certificate). BULB CONTROL PANEL LIGHT REPLACEMENT I I I II I Fan On/Off Mid Speed High Speed Delay Switch Light On/Off Delay switch - Fan will remain on at low, mid or high speed for 5 mins. beforeswitching off automatically. MANUFACTURED FOR BY: ROBINHOOD LIMITED 6 ZELANIAN DRIVE, EAST TAMAKI AUCKLAND, NEW ZEALAND ISO9001 Certified Electrical Rating: 346W (1.44A) Max at 230 - 240V 50Hz WARNINGS • Care should be taken when removing filters in order to prevent the filterfalling and causing damage to the hob top. • Remove transport tape from the lights and filters before use. • This appliance is not intended for use by young children or infirm persons withoutsupervision. • Young children should be supervised to ensure that they do not play with theappliance. • Upon installation the appliance must be positioned so that the plug isaccessible. • There should be adequate ventilation of the room when the rangehood is used atthe same time as appliances burning gas or other fuels. • You must read the details concerning the method and frequency of cleaning. • There is a fire risk if cleaning is not carried out in accordance with the instructions. • Do not flambe under the rangehood. • Exhaust air must not be discharged into an existing flue used for exhaustingfumes from appliances burning gas or other fuels. • The recomended minimum distance between the hob surface and the lowest partof the rangehood is 610mm (24”). This should be increased to at least 660mm(26”) (preferably 685mm (27”)) if installed over a gas hob. • Attention should be given to ensure that any applicable regulations concerningthe discharge of exhaust air is fulfilled. • If the supply cord of this equipment is damaged, it must only be replaced by themanufacturer or it’s service agent, or a similarly qualified person in order toavoid a hazard. • Care should be taken when servicing the light panel due to a shortswitch wire. INSTALLATION INSTRUCTION PRODUCT DIMENSIONS PLEASE READ THE ENTIRE INSTRUCTIONS BEFORE INSTALLING THE CANOPY Titan Canopy 88795 (UK) RH361 RH361M RH361 RH361M 88796 (UK) 87978 (NZ/AUS) 87979 (NZ/AUS) 914mm (36”) 364mm (14 ~ 5/16”) 320mm (12 ~ 5/8”) 465mm(18 ~ 5/16”)min 615mm(24 ~ 3/16”) max 895mm(35 ~ 1/4”) 120mm(4 ~ 3/4”) 565mm (22 ~ 1/4”) a) Switch off the power to rangehood. b) Use a small bladed screwdriver to prise off the light cover. c) Use a cloth to remove the bulb. Do not touch the bulb with fingers. d) Replace with a new bulb using a cloth. Do not touch the bulb with fingers. “Snap” the cover back in place. e) Halogen bulb 12Volt/20Watt required. 104735 issue E ECN: 04 101 For other accessories, parts or service, please contact your local supplier(Refer to the Warranty Certificate). BULB CONTROL PANEL LIGHT REPLACEMENT I I I II I Fan On/Off Mid Speed High Speed Delay Switch Light On/Off Delay switch - Fan will remain on at low, mid or high speed for 5 mins. beforeswitching off automatically. MANUFACTURED FOR BY: ROBINHOOD LIMITED 6 ZELANIAN DRIVE, EAST TAMAKI AUCKLAND, NEW ZEALAND ISO9001 Certified Electrical Rating: 346W (1.44A) Max at 230 - 240V 50Hz WARNINGS • Care should be taken when removing filters in order to prevent the filterfalling and causing damage to the hob top. • Remove transport tape from the lights and filters before use. • This appliance is not intended for use by young children or infirm persons withoutsupervision. • Young children should be supervised to ensure that they do not play with theappliance. • Upon installation the appliance must be positioned so that the plug isaccessible. • There should be adequate ventilation of the room when the rangehood is used atthe same time as appliances burning gas or other fuels. • You must read the details concerning the method and frequency of cleaning. • There is a fire risk if cleaning is not carried out in accordance with the instructions. • Do not flambe under the rangehood. • Exhaust air must not be discharged into an existing flue used for exhaustingfumes from appliances burning gas or other fuels. • The recomended minimum distance between the hob surface and the lowest partof the rangehood is 610mm (24”). This should be increased to at least 660mm(26”) (preferably 685mm (27”)) if installed over a gas hob. • Attention should be given to ensure that any applicable regulations concerningthe discharge of exhaust air is fulfilled. • If the supply cord of this equipment is damaged, it must only be replaced by themanufacturer or it’s service agent, or a similarly qualified person in order toavoid a hazard. • Care should be taken when servicing the light pane...
Este manual também é adequado para os modelos :Fans - RH361M (217.18 kb)