Assessments - 0, GPA: 4 ( )

Fabricante : Electrolux Arquivo Tamanho: 675.01 kb Arquivo Nome : 6932000en.pdf Língua de Ensino:

Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. This disconnector may be for example a switch, fuses (plug fuses must be removed from the fuse box, fault current switches and remote switches with a distance of over 3 mm between contacts. The manufacture declines all responsibility for malfunctions resulting from failure to comply with the above instructions. If the power socket is applied directly above the hood this gives two advantages: 1. the socket is not visible. 2. the appliance can be disconnected at need merely be removing the plug. Electrical connection 220-240 V – by means of fixed power cable with plug. (Fixed connection of the appliance must only be carried out by an authorised electrician.) Wall unit mounting - Fig. 7 • Put the template onto the wall (1) and drill two O12mm holes (2). • Fit two hooks (3) on the drilled holes. • Hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (5). • Remove the metal filters (4) and mark two points (6). Remove the hood and drill two O8mm holes on the marked points. Fit two O8mm wall dowels (7), Hang again the hood and fix the hood definitively with two screws 5X45 (8). • Fix the chimney support (10) with two screws 5 x 45 mm (9) and two wall dowels (11) on the wall close to the ceiling. • For exhausting version: Fit the connection ring (S) on the top of the hood with two screws O 3,5 x 6,5 mm (12S) then fit an axhausting pipe long enough to reach the outside (13S). For recycling version: Fix definitively the deflector (13K) on the top of the hood with two screws O 3,5 x 6,5 mm (12K). • Prepare the electric connection (14) (see relative chapter). • Fit the chimney (15) and fix it on the chimney support with two screws 3,0 x 9 mm (16). The lower part of the chimney must be slided down and inserted on the housing on the upper part of the hood (17). • Fit the two grids (18) on both sides of the chimney. 78 (Signature invalid, document altered) Signed by Gismondi Stefano Time: 2002.03.28 10:42:35 +01'00' Reason: Approvo questo documento di cui sono l'autore-visionato dal cliente Location: Fabriano 79 Fig. 7 O 120 mm AEG Hausgerate GmbH Postfach 1036 D-90327 Nurnberg © Copyright by AEG LI1USB Ed.03/02 ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :