Display Section................................................................................3-19 3-3. Rear panel Section...........................................................................3-26 ANALOG INPUT/OUTPUT connector...........................................................3-27 DIGITAL INPUT/OUTPUT connector...........................................................3-28 REMOTE connector........................................................................................3-29 TIME CODE INPUT/OUTPUT connector......................................................3-32 EXT SYNC connector.....................................................................................3-33 AC IN connector, GND terminal......................................................................3-36 D-25 Owners Manual Chapter 3 3-1. Front Panel Section Cassette tray INSTANT START key AUTO CUE key BLANK SEARCH key S-ID SEARCH key RECORD button STOP button PLAY button REWIND button F FWD button Refer to pages 3 - 3 ~ 3 - 6. CONFIDENCE MONITOR key AUDIO MONITOR key MUTE key ASSEMBLE key AUDIO INSERT key TC INSERT key Refer to pages 3-14 and 3-15. MEM LOC key RECALLS key MARK SET key SETUP key Refer to pages 3-10 and 3-11, FL display DISP TIME key DISP LEVEL key MARGIN RESET key Refer to page3 -7. JOG dial SHUTTLE dial JOG/SHTL key RAM SCRUB key PREVIEW/REPEAT key Refer to pages 3 - 8 and 3 - 9. 3-1 D-25 Owners Manual Chapter 3 POWER switch OPEN/CLOSE key PHONES knob PHONES jack O " ■ POWER switch Switches the power on or off to the main unit. ■ OPEN/CLOSE key The cassette tray will open or close alternately with each press of this key. If a tape is set in the tray when it is closed, tape will be loaded and the D-25 will enter the pause mode. To close the tray, use the following procedures: 1. Press the PLAY button (the tape will load and the D-25 will enter PLAY). 2. Press the STOP button. 3. Lightly press front edge of the tray. * The cassette tray can be opened only while in the STOP or PAUSE modes. * While in the INSTANT START mode off state, if the tape is in a non-recorded section when loaded, the D-25 will automatically enter the BLANK SEARCH mode. * Refer to chapter 4 (page 4 -14) for details on BLANK SEARCH. ■ PHONES (headphone sound volume) knob Adjusts the headphone monitoring level. In the SETUP mode, if the reference level is changed, the monitor output level will also change. * Refer to chapter 9 (page 9-5) for details on to set the reference level. ■ PHONES (headphone) jack Receptacle for the headphone plug. o I o D*25 DOTAL. MM mwwi v ms vw □ □ I piecq» pgror or 3-2 D-25 Owners Manual Chapter 3 Cassette tray INSTANT START key AUTO CUE key □ □ O O .r:::......m "'o *0 ’□ 'da !□!□□□□ § asiÉ □ D-25 DKITAL MASTER R£COflC€R MTjMT AUTO mwt tTMT » WMI 0*Tl *T O CUE OHM« 0 m O |3 o p~~a omhmp Dit» ►play «Mw» t*r m Cassette tray The DAT cassette tape is placed here. Opening and closing of the tray can be done by the OPEN/ CLOSE key, STOP or PLAY buttons. * Refer to chapter 2 (page 2 * 6) for details on setting of the cassette tape. INSTANT START key With each press of this key, the INSTANT START mode will alternately switch on or OFF. INSTANT START can be executed only when the LED is lit. If this LED is blinking either fast or slow, the D-25 cannot INSTANT START for the following reasons: Blink (slow) Audio data is being stored into the RAM. Proceed to the next operation after it changes to constant liaht. Blink (fast) Instant start cannot be executed because there is no A-TIME or time code recorded on the tape. Rerecord A-TIME or TC on the tape. When the AUTO CUE and INSTANT START modes are in the on state, the AUTO CUE mode will swwitch off simultaneous with switching off of the INSTANT START mode. Refer to chapter 4 (page 4 - 25) for details on INSTANT START. ■ AUTO CUE key The AUTO CUE mode switches on or off alternately with each press of this key. If this key is pressed while the INSTANT START mode is off, this mode will switch on at the moment this key is switched on. * Refer to chapter 4 (page 4 - 30) for details on the AUTO CUE mode. D-25 Owners Manual Chapter 3 BLANK SEARCH key START ID SEARCH (« ») key ■ BLANK SEARCH key Non-recorded sections of tape will be searched for when this key is pressed. The LED will light during search and extinguish when search is finished. If an END-ID is recorded on the tape, the D-25 will pause two seconds before this END-ID. * Recording or erasing of END-IDs is not possible with the 0-25 alone. * A non-recorded section of 9 seconds or less might not be found in certain cases. * Refer to chapter 4 (page 4 -14) for details on Blank Search. ■ START ID SEARCH (« >>)key An S-ID search for the number of times this key is pressed will be executed. The LED will light during execution and extinguish at the finish of execution. This function cannot be execu...
)
