Assessments - 2, GPA: 3
(
)
)
|
Facilidade de uso
In case the dirt is hard to remove, use a mild detergent and wipe gently. • Do not drop any metallic parts through slots. This action could damage the appliance permanently. Turn the power off immediately and refer servicing to qualified service personnel. • Use the appliance under conditions where temperatures are within -10°C - +50°C (14°F - 122°F), and humidity is below 90%. The input power source is 120V AC 60 Hz. Do not operate the appliance in an extreme environment where is out of its specified temperature or humidity range, or power source ratings. MAJOR OPERATING COMPONENTS AND THEIR FUNCTIONS © Power On/Off Switch (POWER, ON/OFF) This switch is used to turn the camera drive unit and connected specified camera power on or off. The indicator lights up when the power of the camera drive unit is on. (2) Cooling Fan Unit This unit prevents the temperature of the camera drive unit from rising Caution: Do not block the ventilation opening or slots on the cover to prevent the temperature of the camera drive unit from rising. The power indicator blinks to indicate an unusual temperature rise. Do take immediate action when the power indicator blinks. Turn the power off and refer servicing to qualified service personnel. (3) Camera Input Connector (CAMERA IN) This connector receives either a color or B/W composite video signal from the specified camera. It also supplies DC power and vertical drive pulses or synchronizing signals to the camera, and receives video and audio signals from the camera. © Video Output Connector (VIDEO OUT) The video signal of the specified camera is provided at this connector for input into the video monitor. (5) Audio Output Connector (AUDIO OUT) The audio signal of the specified camera is provided at this connector for input into the video monitor (used with the WV-CF20 or WV-CP100 camera.). © VD/SYNC Input Connector (VD/SYNC IN) The VD (Vertical Drive) pulse or VS (Video Sync) signal is supplied to this connector for synchronizing the system. (7) VD/SYNC Output Connector (VD/SYNC OUT) The VD (Vertical Drive) pulse or VS (Video Sync) signal is provided at this connector for synchronizing other system components. Note: Be sure that the specified camera and camera input (1ch) are connected correctly and firmty. The synchronizing signal is not supplied if this connection is faulty. INSTALLATION Mounting in the Rack 1. Loosen and remove four screws on the bottom of the camera drive unit, and remove four rubber feet. 2. Place the rack mounting brackets on both sides of the camera drive unit and tighten the supplied screws. 3. Install the camera drive unit with the rack mounting brackets in the rack by using four screws (not supplied.) Cautions: • Do not block the ventilation opening or slots on the cover to prevent the appliance temperature from rising. Always keep the temperature in the rack within 50 °C (122 °F). • Fix the rear of the appliance on the rack by using an additional mounting bracket (not supplied) if the appliance is exposed to vibration. -3- CONNECTIONS Cautions: • Set the POWER switch of the camera drive unit to OFF (JL) during connections. If the power of the camera drive unit is ON during connections, the protection circuit that protects it in case of wrong connection will operate and prevent the camera from functioning. • Connect only a specified camera, WV-BP70, WV-CF20 or WV-CP100. If another camera is connected, the camera drive unit will not operate due to activation of the protection circuit. • Be sure to connect the specified Camera and camera input (1ch) correctly.