Assessments - , GPA: ( )

Instruções de Operação Holmes, Modelo HAP244

Fabricante : Holmes
Arquivo Tamanho: 757.93 kb
Arquivo Nome :

Língua de Ensino:

O documento está colocado, por favor, espere

Baixe o seu Fechar

O documento está colocado, por favor, espere

Baixe o seu Fechar

THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC (Alternating Current) PLUG (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact qualified personnel to install the proper outlet. DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG IN ANY WAY. PRE-OPERATING INSTRUCTIONS 1. Carefully unpack your Air Purifier. Select a firm, level place where there are no obstructions to the air inlet (front grill) or filtered air outlet (top of unit). A good location in a room is about 2 feet above the floor and approximately 1 foot away from the wall, in a central location of your home. 2. Remove front grill by pulling the grill towards you (see fig. 1). 3. Remove the HEPA filter by gripping on both sides and pulling forward. 4. Remove protective plastic bag from the filter cartridge. The filter clip can only be attached to the hang tabs on the filter one way. The filter clip should easily slide onto the filter hang tabs with only a small amount of pressure. Do not use force while attaching the filter clip to the filter. Align the clip on the top of your HEPA filter with the rails on the inside of the unit. Gently slide the filter onto the rail (see figure 2). NOTE: The pleated material and rubber gasket should be facing towards the unit when applied. 5. Replace front grill by sliding back onto unit. Make sure that it snaps securely into position (grill only goes on one way). NOTE: Do not point outlet towards wall. DUAL POSITION – The air purifier can stand upright or lie on its side. Also designed to fit with its back flush against the wall. When positioning the unit please be sure the air inlet grill, filters and air outlet are not blocked to ensure maximum airflow. EQUIPPED with GE motor for quieter performance and the added durability necessary for continuous use. Filter check indicator – The filter check indicator will illuminate red when it is time to change the filter CLEANING INSTRUCTIONS Turn off and unplug the unit before cleaning. 1. The outside of the air purifier can be cleaned with a soft, clean, dampened cloth. 2. The front grill can be removed and washed in warm soapy water (Not dishwasher safe). Dry before replacing in the unit. 3. The top air outlet grill can be cleaned of dust with a small soft brush. WARNING: Do not allow moisture to come in contact with the main housing of the air purifier. FILTER REPLACEMENT INSTRUCTIONS 1. Every few weeks, check the condition of the pre-filter. 2. Remove the front grill. Examine the foam pre-filter. If the pre-filter has collected a noticeable amount of dust or lint, remove it from the inlet of the grill and wash it in warm soapy water. Rinse and drip dry the pre-filter thoroughly before replacing it in the inlet of the grill. 3. The filter check indicator light on the control panel will illuminate when HEPA filter replacement is needed. 4. With the front grill...