Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
• The width of the extractor hood must correspond to the width of the cooking area. • The extractor hood must not be installed over a solid fuel heating appliance which may be a fire risk (e.g. flying sparks) unless the heating appliance has a closed, non- detachable cover and the country-specific regulations are observed.This restriction does not apply to gas cookers and gas hobs. • To avoid damaging the hob, cover it when installing the extractor hood. Operating modes • The extractor hood can be used in exhaust air and circulating air mode. Exhaust-air modeAppliance dimensions Exhaust air The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system. Circulating-air modeAppliance dimensions Circulating air The air which is drawn in is cleaned by the grease filters andan activated carbon filter and conveyed back into the kitchen. An activated carbon filter must be installed to bind odours in circulating-air mode (see ”Removing and installing the grease filters”). The complete installation set as well as the replacement filters are available from specialist outlets, customer service or the Online Shop. The accessory number can be found at the end of the operating instructions. Operation Fan Intensive Grease filter saturation On/Off setting display Fan settings Fan run-on Light • The appliance is operated by gently the tapping the sensor buttons. NOTE:It is recommended to switch on the blower when you start cooking and not to switch it off again until several minutes after you have finished cooking. In this way the kitchen fumes are removed most effectively. Switching on the fan and selecting the fan settings • Press theW button. The fan switches to setting2. • Press the appropriate button to select the required fan settings. Switching off the fan • Press theW button. Intensive setting The Intensive setting generates maximum performance. It can be used if thick fumes or strong odours occur temporarily. • Press the q button. • If the Intensive setting is not switched off by hand, the fan automatically switches back to setting 2 after 10 minutes. Fan run-on • Press the p button. • The fan runs for 10 minutes at the selected setting. Then the fan switches off automatically. Light • The light can be switched on and off independently of the fan. • To adjust the luminosity, hold down the 0 button until the required luminosity is obtained. Saturation displays • When the grease filters are saturated, a signal sounds for 6 seconds after the fan is switched off. TheJdisplay is lit. The grease filters should be cleaned now. • To cancel the display, press the Jbutton. Switching the acoustic signal off and on • When a button is pressed, an acknowledgement signal sounds. • To switch off the acoustic signal, simultaneously press the 0andp buttons for approx. 3 seconds. An acknowledgement signal sounds. • To switch on the acoustic signal, repeat the process. Locking the buttons • To lock the buttons, simultaneously press 0 and q. The buttons are locked for approx. 30 seconds. • To release the buttons early, repeat the process. Cleaning and care LOOKINGAFTERTHEAPPLIANCE • Suitable cleaning agents and care products for your appliance can be purchased via the Hotline or from the Online Shop (see cover page). Appliance surfaces NOTE: Observe the warranty regulations in the enclosed servi...
Este manual também é adequado para os modelos :Hoods - DIB099950/02 (3.53 mb)
Hoods - DIB129950/01 (3.53 mb)
Hoods - DIB129950/02 (3.53 mb)
Hoods - DIT099850/01 (3.53 mb)