Assessments - 0, GPA: 0 ( )

Fabricante : Bosch Arquivo Tamanho: 5.2 mb Arquivo Nome : Língua de Ensino:

Detach the grease filter by pulling it towards yourself. Activated carbon filter Removing and installing the activated carbon filter Extractor hoods with a filter mat: 1. Remove the filter; see grease filter. . The wire grille is no longer required when an activated carbon filter is installed. 2. Clean the grease filters. 3. Re-insert the clean grease filters. 2. Place the activated carbon filter on the filter mat and clamp it in. 3. Install the filter frame. . See grease filter. Activated carbon filter Extractor hoods with two filter cartridges: 1. Remove the filter cartridge. . See grease filter. 2. Insert the screw through the wing nut and the sleeve and screw in the middle screw in the false bottom (required only during the initial installation). Screw, sleeve and wing nut are enclosed with the activated carbon filter. 3. Using a screwdriver, press in the two lugs on the false bottom. If a spacer rail has been installed, it must be removed. 4. Tape over the activated carbon filter with the enclosed sealing strip. 5. Insert the activated carbon filter at the rear, fold up and lock in the middle with the wing nut. If the spacer rail has been removed, it must be re-installed. 6. Re-insert the two filter cartridges. Removing the activated carbon filter: . The activated carbon filter is removed in reverse sequence. Changing the activated carbon filter: If used normally (1 to 2 hours daily), the activated carbon filter should be changed approx. once a year. Activated carbon filters can be purchased from SPECIALIST OUTLETS (see optional accessories on the last page). Use original filters only. This will ensure optimum performance. Disposing of the old activated carbon filter: Activated carbon filters do not contain any pollutants. They can be disposed of e.g. as residual waste. Cleaning and care Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. . At the same time as you renew the grease filter (see Filters and maintenance), clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. . Clean the extractor hood with a hot detergent solution or a mild window cleaning agent. . If the hood is extremely dirty (older stains), use a liquid window cleaner. . Do not scratch off dried-on dirt, but wipe off with a damp cloth. . Do not use scouring agents. Warning: Clean the control buttons with a mild detergent solution and a soft, damp cloth only. Painted, aluminium and plastic surfaces: . Do not use scouring agents or abrasive sponges. . Do not use dry cloths. . Do not use corrosive, acidic or alkaline cleaning agents. . Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. . Caution! Ensure that the kitchen is adequately ventilated. Avoid naked flames. Changing the bulbs 1. Switch off the extractor hood and iso...

Baixe o seu

Para fazer o download, introduza 2 dígitos :