Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
Electrical data: Preparing the wall . The wall must be flat and perpendicular. . Ensure that the wall is capable of providing a firm hold for mounting screws and plugs. Weight in kg: Are to be found on the name plate inside the appliance after removal of the filter frame. Before undertaking any repairs, always disconnect the extractor hood from the electricity supply. Exhaust air Recirculating air 60 cm 12,5 13,5 70 cm 13,0 14,0 90 cm 13,9 14,9 100 cm 14,5 15,5 We reserve the right to construction changes within the context of technical development. Electrical connection Length of the connecting cable: 1.30 m. If it is necessary to wire the extractor hood directly into the mains: The extractor hood should only be connected to the electricity supply by a properly qualified electrician. A separator must be installed in the household circuit. A suitable separator is a switch that has a contact gap of more than 3 mm and interrupts all poles. Such devices include circuit breakers and WARNING: THIS APPLIANCE MUST BE EARTHED IMPORTANT: Fitting a Different Plug: The wires in the mains lead are coloured in accordance with the following code: Green and Yellow – Earth Blue – Neutral Brown – Live If you fit your own plug, the colours of these wires may not correspond with the identifying marks on the plug terminals. contactors. If the connecting cable for this appliance is damaged, the cable must be replaced by the manufacturer or his customer service or a similarly qualified person in order to prevent serious injury to the user. This extractor hood corresponds to EC regulations concerning RF interference suppression. Installation This extractor hood is intended to be mounted onto the kitchen wall. 1. Remove the grease filter (refer to Operating Instructions). 2. Draw a line on the wall from the ceiling to the lower edge of the hood at the centre of the location where the hood is going to be mounted. 3. Using the template, mark positions on the wall for the screws. Ensure that the minimum distance between the hob and the extractor hood is maintained – 550 mm for an electric hob and 650 mm for a gas hob. The bottom edge of the template equates to the lower edge of the extractor hood. Note: Take into account any special accessories that are going to be fitted. 5. Screw on the 2 brackets for fixing the upper and lower flue ducts. 6. In order to help fix the hood onto the wall, screw in the middle screw (without a washer) until it protrudes by approx. 5 mm. 7. Hook the extractor hood over the screw in the wall 4. Drill 5 holes (dia. 8 mm) for the extractor hood and 4 holes (dia. 8 mm) for the brackets for fixing the flue ducts and insert wall plugs flush with the wall. 228 228 27 465 220 400 68 113 39 mind. 550 Elektro 650 Gas 5 ca. 5mm Installation 8. Insert the other 4 screws with washers. Before the 4 screws are tightened down, align the extractor hood properly. 9. Connect up the air outlet pipe. 10. Connect the hood to the electricity supply. 11. Stainle...
Este manual também é adequado para os modelos :Hoods - D69B20W0/01 (2.32 mb)
Hoods - D8602N0/06 (2.32 mb)
Hoods - D8602N0/07 (2.32 mb)
Hoods - D8602S0/06 (2.32 mb)