|
Facilidade de uso
– 89/336/EWG dated 3 May 1989 (including guideline change notice 92/31/EWG) Fix cover (C) on guide (A) until it clips into place. Open the appliance door and the furniture door at 90°. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with o 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door the furniture closes properly. PR33 C A 8mm PR167 A B PR168 extinguisher refill cartridges etc in the refrigerator/freezer. • Bottles and cans must not be placed in the freezer compartment. They can burst when the contents freeze, high carbonate content drinks can even explode! Never store lemonade, juices, beer, wine, sparkling wine etc. in the freezer compartment. • Ice cream or ice cubes can cause “frost/freezer” burns if consumed straight from the freezer. • Do not touch frozen food with wet hands. Your hands could freeze to the food. • Do not operate any electrical appliances in the refrigerator/freezer (e.g. electric ice cream makers, mixers etc.). • Before cleaning the appliance, always switch off the appliance and disconnect from the electricity supply. • When unplugging always pull the plug from the mains socket, do not pull on the cable. Service • Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local AEG Service Force Centre. Disposal Appliance Packaging Information All materials are environmentally sound. The plastics can be recycled and are identified >PE< for polyethylene, e.g. the outer covering interior. >PS< for polystyrene foam, e.g. the The carton parts are made from dispo sed of at a waste-paper recycling Disposal of old Appliances For environmental of properly. This applies to your its service life Warning! Before disposing of old appliances make them inoperable. Remove plug from mains, sever the power cable, remove or destroy any snap or latch closures, to prevent small children being trapped inside. • Use an authorised disposal site. Remove transport safeguard The appliance and the interior fittings are protected for transport. • Remove all adhesive tape and packing pieces from the interior of the appliance. You can remove any remnants of adhesive using white spirit. Apply covers (B) on joint cover lugs and into hinge holes. D726 B Separate parts A, B, C, D as shown in the figure Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix guide with the screws supplied. B A C D PR266 20 mm A50mm PR166 Instructions for building-in Apply joint the sealing strip as shown in figure. Push appliance into the housing until stop strip (A) touches the kitchen unit. Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with screws provided in the included with the appliance. Snap vent grille cover (D) into A D023 D765 D CD723 Starting up and temperature regulation Wash the inside of the appliance with lukewarm water with a little bicarbonate of soda added (5ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry the appliance thoroughly. • When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature selector knob is located on the RH side of the refrigerator compartment. Setting “0”: Off. Setting “1”: Hightest temperature, (warmest setting) . Setting “6” (end-stop) : Lowest temperature, (coldest setting) . The exact setting should be chosen keeping in mind that the tempe rature inside the refrigerator depends on: -the quantity of food stored -how often the door is opened The temperatures in the refrigerator compartment and freezer com partment cannot be independently regulated. If you want to freeze fresh food rapidly, select setting “6”, ensuring that the temperature in the refrigerator compartment does not drop below 0°C. You should also promptly reset the temperature regulator to setting “3” or “4”, if this occurs. Important! High ambient temperatures (e.g. on hot summer days) and on the temperature regulator (position"5" to "6") can compressor to run continuously. If this happens, turn the temperature regulator back (position "3" to "4"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. Ambient Temperature switch With a room temperature below +16°C the Fridge freezer may not function correctly. If the room temperature is lower than +16°C it will be necessary to depress (A). The relevant pilot light comes on. D710 A 1. Unsc...
Este manual também é adequado para os modelos :Frigoríficos - 2842-6 I (105.76 kb)
Frigoríficos - 2842-6 I (105.76 kb)
Frigoríficos - 2842-6 I (105.76 kb)
Frigoríficos - 2842-6 I (105.76 kb)