Assessments - 4, GPA: 4.8 ( )

Fabricante : AEG Arquivo Tamanho: 754.2 kb Arquivo Nome : 472f0ef2-5c70-4a51-91ba-b338dea85f87.pdf Língua de Ensino:

0 1. The FROSTMATIC function is switched on by pressing the FROSTMATIC button. The yellow light illuminates. The compressor runs continuously. 2. The FROSTMATIC function can be ended manually at any time by pressing the FROSTMATIC button again. The yellow light goes out. If the FROSTMATIC function is not ended manually, the appliance electronics switch off the FROSTMATIC function after approx. 50 hours. The yellow light goes out. Important! Once the FROSTMATIC function has been switched on the DESIRED temperature that was set originally cannot be changed. ALARM OFF button With the ALARM OFF button, the acoustic warning signal can be switched off, e.g. the "Open Door" warning when sorting in or out, the food to be frozen. When there is a temperature warning, if the ALARM OFF button is activated, the temperature display will show the warmest temperature the frozen food has reached. 818 35 95-02/7 Prior to Initial Start–Up 1 Before connecting the appliance to the mains and putting it into operation for the first time, leave the appliance to stand for 30 minutes if was transported upright. After transport on its side, the appliance must be left to stand for 2 hours before putting it into operation. This is necessary to allow the refrigerant to flow back into the compressor. Otherwise the compressor may be damaged. 0 1. Please clean the appliance interior and all accessories prior to initial start-up (see section: “Maintenance and Cleaning”). 2. The appliance must be correctly installed in accordance with the chapter "Installation" before it is put into operation for the first time. Care should be especially taken that the mains voltage and frequency available correspond with the appliance’s rating plate. 3. Remove the cold accumulation block from the appliance. 4. Only put the cold accumulation block to freeze in the top compartment after the optimal storage temperature of –18 °C has been reached. 5. After 24 hours place the cold accumulation block in the uppermost compartment, at the front, above the frozen food. 6. Re-freeze the thawed cold accumulation block in the same way, e. g. after cleaning the appliance. Initial use 0 1. Insert plug into mains socket. 2. Press the ON/OFF button. A warning tone sounds and the red warning light flashes indicating that the required storage temperature has not yet been reached. 3. Press the ALARM OFF button to switch off the warning tone. 4. Set temperature to -18°C or colder (see section: "Temperature Adjustment"). Important! Wait until the freezer compartment has reached a temperature of –18 °C, or the red warning light has gone out, before storing frozen food. 818 35 95-02/7 Temperature Adjustment 0 1. Press either the „+“ (WARMER) or „-“ (COLDER) button. The temperature display switches over and the DESIRED temperature currently set flashes on the temperature display. 2. To adjust to a warmer temperature, press the „+“ (WARMER) button. To adjust to a colder temperature, press the „-“ (COLDER) button. The changed setting is immediately displayed on the temperature display. Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. Temperature range that can be set: -15 °C to -24 °C. Note: From a food safety point of view, -18 °C for the freezer compartment should be considered cold enough as a storage temperature. 3 If the buttons are not pressed again for approx. 5 seconds the temperature display will change from the DESIRED temperature to the ACTUAL temperature. The display changes from flashing to illuminated numbers. Important! Please check red warning display and temperature display regularly to ensure maintenance of the storage temperature. 818 35 95-02/7 Switching the Appliance Off In order to protect frozen goods, the appliance is guarded against accidental switching off (child-proof). 0 1. To switch off press and hold the ON/OFF button for approx. 5 seconds. A so-called "count down" is started in the temperature display, which counts backwards from "3" to "1". After "1" is reached the appliance switches off. Illumination at the temperature display goes off. 3 The appliance is only completely disconnected from the electricity supply when the power plug has been removed from the power outlet. Note: The appliance cannot be switched on or off if unplugged, or if there is no power being supplied to it. Following connection to the mains power supply, the appliance returns to the same operating state as before the interruption of main power. If the appliance is not going to be used for an extended period: 0 1. Switch appliance off by pressing and holding the ON/OFF button for approximately 5 seconds (see above). 2. Unplug or switch off at the mains supply. 3. Clean thoroughly (see section: "Maintenance and Cleaning"). 4. Leave door open to avoid accumulation of odours. 818 35 95-02/7 Control and Information Systems The control and information systems consist of the temperature display, an optical warning display and an acoustic warn...

Baixe o seu

Para fazer o download, introduza 2 dígitos :