Assessments - 4, GPA: 4.5 ( )

Fabricante : Carrier Arquivo Tamanho: 102.93 kb Arquivo Nome : 236331en.pdf Língua de Ensino:

Change the defective light bulb. Refit the light bulb cover. Put the refrigerator back into opera- tion. Regulations, Standards, Guidelines This appliance was designed for household use and was manufactured in accordance with the appropriate standards. The necessary measures in accordance with appliance safety legislation regulations (GSG), accident prevention regulations for refrigeration appliances (VBG 20) and the regulations of the German Society of Electrical Engineers (VDE) were observed in the manufacture of this appliance. The refrigerant circuit has been checked for leaks. This appliance is in accordance with the following EU guidelines: – 73/23/EWG dated 19 February 1973 - low voltage guidelines. – 89/336/EWG dated 3 May 1989 (including guideline change notice 92/31/EWG) - EMV guideline Malfunction The food is too warm. Interior lighting does not work. Heavy build up of frost, possibly also on the door seal. Unusual noises. The compressor does not start immediately after changing the temperature setting. Water on the floor or on storage shelves. Possible Cause Temperature is not properly adjusted. Door was open for an extended period. A large quantity of warm food was placed in the appliance within the last 24 hours. The appliance is near a heat source. Light bulb is defective. Door seal is not air tight (possibly after changing over the hinges) . Appliance is not level. The appliance is touching the wall or other objects. A component, e.g. a pipe, on the rear of the appliance is touching another part of the appliance or the wall. This is normal, no error has occurred. Water drain hole is blocked. Remedy Please look in the "Initial Start Up" section. Open the door only as long as necessary. Turn the temperature regulator to a colder setting temporarily. Please look in the "Installation location" section. Please look in the "Changing the Light Bulb" section. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand such that it sits correctly. Readjust the feet. Move the appliance slightly. If necessary, carefully bend the component out of the way. The compressor starts after a period of time. See the "Cleaning and Care" section. Rehingeing the door The appliance’s door has been locked in position for transport by means of pins on both sides.According to the door opening direction, remove relevant pins at the top and at the bottom. Warning! When changing the side at which the door opens, the appliance may not be connected to the mains. Remove plug from the mains beforehand. Housing dimensions Height 1780mm Depth 550 mm Width 560 mm Electrical connection Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. e.g. : AC 220 ... 240 V 50 Hz or 220 ... 240 V~ 50 Hz (i.e. 220 to 240 volts alternating current, 50 Hertz) The ratin...

Baixe o seu

Para fazer o download, introduza 2 dígitos :