Assessments - 4, GPA: 4.5
(
)
)
|
Facilidade de uso
• INTERIOR LIGHT (MODEL OBC32SS ONLY) The interior light with be turned ON every time the door is opened and OFF once the door is closed. • REVERSING THE OPENINGSWING OF YOUR BEVERAGE COOLER (MODEL 0BC32SS – ONLY_ This appliance has the capability of the door opening from either the left or right side. The unit is delivered to you with the door opening from the left side. Should you desire to reverse the opening direction, please call service for reversal instructions. 11 OPERATING YOUR REFRIGERATOR (MODEL OBC33SSD) IMPORTANT SAFEGUARDS As a natural result of condensation, in summer months or areas of high humidity, the glass door may build up moisture on the outside. Just wipe it away. It is recommended you install the Refrigerator in a place where the ambient temperature is between 50.F - 100.F (10. - 38.C ). If the ambient temperature is above or below recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The range of 36. - 64. F (2. - 18. C) may not be reached. • CONTROL PANEL (MODEL OBC33SSD – ONLY) The unit turns on automatically once plugged in. Your beverage center is equipped with an electronic display that once any button is pressed the display window will light on and will automatically light off two (2) minutes after the last button was pressed. CONTROL PANEL FEATURES / DESCRIPTIONS Alarm Indicator Alarm mode: In the event there is a fault in the unit, an Alarm indicator will appear in the area shown above on the control panel. If at any time the following messages are shown in the display window, consult an Avanti Products Authorized Service Center. . PROBE ERROR . LOW TEMP . HIGH TEMP Compressor Run Indicator When the unit’s compressor is running, the control panel will display a moving “FAN” icon. Once the compressor stops running the icon will also stop moving. Temperature Display The set temperature and current average temperature of the unit will be displayed in this area as shown above. SET Button Use this button to activate the temperature setting mode and again to confirm the selected temperature setting. Temperature UP / DOWN Use these buttons to select the appropriate temperature. Temperature setting will either advance or decrease each time you press the respective button. Light Switch The interior light can be operated manually by pressing the ON/OFF button on the control panel. The light will automatically turn itself OFF after 5 minutes. NOTE: Avoid extended use of the light as the heat generated by the light bulb can raise the interior temperature of the unit and affect the temperature of the items stored. 12 SETTING THE TEMPERATURE CONTROL (MODEL OBC33SSD – ONLY) . The temperature range for your Beverage Center is 36. -64.F (2.-18.C). . The default temperature set at the factory is 41.F (5.C). Once the unit is plugged in, the default temperature will be displayed in the digital display window. . To adjust the temperature, press the SET button, then use the UP or DOWN buttons to select the preferred temperature. When the selected temperature is shown in the display window of the control panel, press the SET button to confirm the setting. . Once the temperature selection has been confirmed, the actual current temperature of the unit will be shown in the DISPLAY window on the control panel. The temperature shown will vary depending on the amount of items stored and how frequently the door is opened. . In the event of a power outage, your unit is designed to remember the temperature setting and will automatically return to that setting after the power has returned. NOTE: . The temperature sensor monitors the average temperature of the unit. Cold air falls and warm air rises, thus there will be a variation in temperature from the bottom to the top of the unit. The bottom area of the unit will always be slightly cooler than the top area. . The temperature displayed in the control panel is an instantaneous average temperature of the unit and there may be a variation of approximately 0 – 6.F. . If the unit is unplugged, power lost, or turned off you must wait three (3) minutes before restarting the unit. If you attempt to restart before this time delay, the refrigerator will not start. • INTERIOR LIGHT The interior light can be operated manually by pressing the Light ON / OFF button on the control panel. The light will automatically turn itself OFF after 5 minutes. NOTE: Avoid extended use of the light as the heat generated by the light bulb can raise the interior temperature of the unit and affect the temperature of the items stored. You can switch temperature display setting from Fahrenheit to Celsius degree by pushing the UP button and hold for 10 seconds. Fahrenheit or Celsius degrees will appear in the temperature display window . CARE AND MAINTENANCE • CLEANING YOUR REFRIGERATOR . Turn off the power, unplug the appliance, and remove all items including sh...
Este manual também é adequado para os modelos :Frigoríficos - AVANTI OBC33SSD (359.22 kb)