Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
The socket must be close to the appliance and must be freely accessible even after the appliance has been installed. Connect the appliance only to 220240V/50Hz alternating current via acorrectly installed earthed socket. Thesocket must be fused with a 10A to16 A fuse. If the appliance is to be operated in anonEur opean country, check on therating plate whether the indicated voltage and current type correspond tothe values of your mains supply. Therating plate is situated in the bottom lefthand side of the appliance. Thepower cord may be replaced by atechnician only. ! Warning Never connect the appliance to electronic energy saver plugs or to power inverters which convert the direct current to 230V alter nating current (e.g. solar equipment, power supplies on ships). en en Switching on the appliance Press the On/Off button Fig.1/1. Theappliance starts refrigerating. Interiorlight is switched on when the dooris open. At the factory the appliance has been set to the middle setting (3) Operating tips While the refrigerating unit is running, beads of water or hoarfrost form at the back of the refrigerator compartment. Thisis quite normal. It is not necessary to scrape off the frost or wipe off the beads of water. The rear panel defrosts automatically. The condensation collects in the drainage channel Fig.4 and is conveyed to the refrigerating unit where itevaporates. Selecting the temperature The temperature can be set from 1.5. Press button Fig.1/6 for 3seconds until display flashes. Then keep pressing the button until the required setting is displayed. The last setting is saved. Setting 1, low cooling capacity. Setting 5, maximum cooling capacity At a setting of 3 a refrigerator compartment temperature of +8°C to +12°C is reached depending on the ambient temperature and load. Refrigerating capacity The temperature in the refrigerator compartment may rise temporarily if loaded with fairly large amounts of food. Placing bottles in the refrigerator Note when loading products: S Depending on the model, a max. number of bottles can be stored on thebottle shelves, see loading example, Figs.9and0. This number of bottles can be stored ifthe bottles are placed with their necks facing forwards. S To ensure good air circulation in the appliance, the bottles should not be stored opposite each other or touch therear panel of the refrigerator compartment. S The indicated number of bottles may vary depending on the shape and size of the bottles. S The area at the bottom is not very deep on account of the motor compartment. Drinks cans or short wine bottles can bestored. For presentation purposes it is also possible to store the wine bottles upright, Fig.5. Usable capacity Information on the usable capacity can be found inside your appliance on the rating plate. en en Use temperature zones in the refrigerator compartment! The air circulation in the appliance produces different refrigeration zones: The warmest zone is at the top. The coldest zone is at the bottom. Arrange drinks Store different types of wine from top tobottom according to the following sequence: S Haevy red wines S Rose and light red wines S White wine S Champagne and sparkling wines It is recommended to serve the wine a few degrees colder than the required drinking temperature, as the wine warms up quickly when poured into glasses. Practical tips for storing wine S Unpack bottles of wine do not leave incrates or cardboard boxes before storing in the refrigerator compartment. S Place old bottles so that the cork isalways wet. There should never beanair gap between the wine and thecork. S The open bottle shelves are especially suitable because they do not interrupt the air circulation. As a result, the atmospheric humidity which condenses on the bottles quickly dries again. S Before the wine is drunk, it should be “warmed up” (chambre): Place e.g. rose wine on the table approx. 2.5 hours before drinking, redwine 4.5 hours before drinking. Thewine will then be at the correct drinking temperature. Sparkling wine and Champagne should be cooled inthe refrigerator shortly before drinking. S Remember that wine should always becooled slightly lower than the ideal serving temperature, as its temperature increases by 1 to 2 °C assoon as it is poured into a glass! en en Switching offand disconnecting the appliance Switching off the appliance Press the On/Off button Fig.1/1. Refrigerating unit and the light switch off. Disconnecting theappliance If the appliance is not used for aprolonged period: 1. Switching off the appliance. 2. Pull out the mains plug or switch off thefuse. 3. Cleaning the appliance. 4. Leave the appliance door open. Cleaning the appliance Proceed as follows: 1. Pull out the mains plug or switch off the fuse! 2. Wipe the door seal with clear water only and then wipe dry thoroughly. 3. Clean the appliance with lukewarm water and a little washingup liquid. The water must not drip onto the controls or light. 4. After cleaning: reconnect and switch on th...
Este manual também é adequado para os modelos :Frigoríficos - 3FWS1240/03 (822.9 kb)
Frigoríficos - 3FWS1340/03 (822.9 kb)