Assessments - 3, GPA: 3.3
(
)
)
|
Facilidade de uso
NOTE: • If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the refrigerator will not start. • Use of the Ice Cube Trays ? For your ice requirements, fill approximately . of the tray after washing it. ? If you want to make ice cubes quick, set thermostat to “cold” position. ? To release the ice cubes, hold the tray upside down and twist slightly at both ends until the pieces of ice fall. • The Chiller Compartment ? This compartment is designed for production of ice cubes and short term storage (3-4 days at most) of some commercially frozen foods. ? The temperature in this compartment does not get cold enough to freeze food safely for long periods of time and works best when the food is already frozen. ? By design; this chiller compartment is not a true freezer, and may not keep ice cream frozen, or freeze items. ? A colder setting may be used for these items, but other items in the refrigerator may also be affected. ? The chiller door is susceptible to breaking due to excessive ice build up. This part is not covered under your warranty. Be sure to defrost when the ice reaches . inch thick. CARE AND MAINTENANCE • Defrosting Your Refrigerator Defrost the refrigerator when the frost accumulated on the evaporator is about 5mm (1/5 inch) thick. Set the thermostat dial to “OFF” or “DEFROST” position. Remove frozen or perishable foods. Defrosting usually takes a few hours. After defrosting, return the thermostat dial to the desired position. To defrost quickly remove all foods from the refrigerator and leave the door open. Never use a knife or other metal instrument to scrape ice/frost from the evaporator. 10 11 • CHANGING THE REVERSIBLE DOOR The refrigerator has been built with the door hinges on the right. If you wish to change the opening direction, follow the instructions below: Unplug the refrigerator from its electrical outlet. Empty everything in the refrigerator, including shelves, food, etc. ? ? ? ? ? ? Remove the upper hinge cover on the right top of the cabinet Remove all 3 bolts holding the upper hinge to the cabinet along with the spacer underneath. Save these bolts, hinge, and spacer for later use. Remove the plastic caps from the upper left holes and transfer them to the uncovered holes at the right side. Be sure to press the plug buttons firmly into the holes. Incline the refrigerator backward (do not lay it on the floor). Using a pliers remove the right foot. Also remove the two bolts holding the lower hinge to the cabinet. Save the bolts, hinge, and washer for later use. Remove the left foot and transfer it to the opposite side. Insert the lower hinge at the opposite side (left) using the two bolts and washer previously removed. ? Mount the right foot previously removed to the opposite side (left). Then mount the leveling foot ? in the uncovered hole (right). Set the door to its place. ? While holding the door in the closed position, secure the top hinge at the left side using the three ? bolts and spacer previously removed at the beginning of the operation. Do not tighten the bolts until the top of the door is leveled. ? Replace the hinge cover. 12 • Cleaning Your Refrigerator ? Turn the temperature control to "OFF", unplug the refrigerator, and remove the food, shelves, and trays. ? Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. ? Wash the shelves and trays with a mild detergent solution. ? The outside of the refrigerator should be cleaned with mild detergent and warm water. ? Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts. ? Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth. • Vacation Time ? Short vacations: Leave the refrigerator operating during vacations of less than three weeks. ? Long vacations: If the appliance will not be used for several months, remove all food and unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave the door open slightly: blocking it open if necessary. • Moving Your Refrigerator ? Remove all the food. ? Securely tape down all loose items inside your refrigerator. ? Turn the leveling screws up to the base to avoid damage. ? Tape the door shut. ? Be sure the refrigerator stays secure in the upright position during transportation. Also protect outside of refrigerator with a blanket, or similar item. • Energy Saving Tips ? The refrigerator should be located in the coolest area of the room, away from heat producing appliances, and out of the direct sunlight. ? Let hot foods cool to room temperature before placing in the refrigerator. Overloading the refrigerator forces the compressor to run longer. ? Be sure to wrap foods properly, and wipe containers dry before placing them in the refrigerator. ...