Assessments - 3, GPA: 3.7 ( )

Fabricante : DeWalt Arquivo Tamanho: 436.19 kb Arquivo Nome : Língua de Ensino:

So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit. The RBRC™ Seal The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the nickel-cadmium battery (or battery pack) indicates that the costs to recycle the battery (or battery pack) at the end of its useful life have already been paid by DEWALT. In some areas, it is illegal to place spent nickel-cadmium batteries in the trash or municipal solid waste stream and the RBRC program provides an environmentally conscious alternative. RBRC in cooperation with DEWALT and other battery users, has established programs in the United States to facilitate the collection of spent nickel-cadmium batteries. Help protect our environment and conserve natural resources by returning the spent nickel-cadmium battery to an authorized DEWALT service center or to your local retailer for recycling. You may also contact your local recycling center for information on where to drop off the spent battery. Introduction Your charger is designed to use standard 120 volt AC, 60 Hz power. Do not use DC or any other voltage. Charge time is approximately one hour. 2 Important Safety Instructions for BatteryChargers SAVE THESE INSTRUCTIONS: This manual contains important safety and operating instructions. • Before using charger, read all instructions and cautionary markings on (1) charger, (2) battery pack, and (3) product using battery pack. DANGER: 120 volts present at charging terminals. Do not probe with conductive objects. Danger of electric shock or electrocution. DANGER: If battery pack case is cracked or damaged, do not insert into charger. Electric shock or electrocution may result. • DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack are specifically designed to work together. • Do not expose charger to rain or snow. • These chargers are not intended for any uses other than charging DEWALTrechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution. • Pull by the plug rather than cord when disconnecting charger. This will reduce the risk of damage to the cord. • Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. • Do not use an extension cord unless absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution. • An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size. RECOMMENDED MINIMUM AWG SIZE FOR EXTENSION CORDS Total Extension Cord Length (feet) 25 50 75 100 125 150 175 Wire Gauge 18 18 16161414 12 • Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away fro...

Baixe o seu

Para fazer o download, introduza 2 dígitos :