Assessments - , GPA: ( )

Instruções de Operação Associated Equipment, Modelo 9050

Fabricante : Associated Equipment
Arquivo Tamanho: 87.55 kb
Arquivo Nome :

Língua de Ensino:

O documento está colocado, por favor, espere

Baixe o seu Fechar

O documento está colocado, por favor, espere

Baixe o seu Fechar

! Set the SELECT SETTING switch to the START position. Models 9060 and 9090 require setting the SELECT FUNCTION switch to START. ! Charge the battery for at least five minutes before attempting to start the vehicle. ! Start the vehicle with the charger connected to the battery. NOTE: Do not crank the engine more than 20 seconds in any five minute period; excessive cranking may overheat and damage the starter. If the vehicle fails to start, while waiting for the starter to cool, allow the charger to continue to charge the battery. Unplug the charger before disconnecting dc clips from battery. POSSIBLE CHARGING PROBLEMS: 1. ! Meter needle swings to far right side of meter: (Manual). ! Reverse connection indicator is On. Your new battery charger has been equipped with an automatic reset circuit breaker. This protects the charger from temporary overload conditions. A severely discharged battery, a battery with shorted cells, or reversed charger connections at the battery will cause this protective device to operate. Under these overload conditions, the circuit breaker will open, and when cooled down will reset automatically. This cycling process can be identified by a clicking sound made during the opening and closing of the circuit breaker. a. Check for reverse polarity connections. b. If battery is severely discharged, charge meter needle will start to cycle up and down, and will stabilize after 15 to 20 minutes. c. Battery may have one or more shorted cells. Cycling will start immediately and continue indefinitely. If cycling has not stopped as outlined in (b), disconnect charger (AC power cord first) and have battery tested. 2. ! No meter reading: a. Battery is fully charged (charge complete light is on). b. Check connections to battery and engine block or car frame. Be sure polarity is correct (red clip to positive). "Rock" the clips to bite through any dirt or corrosion. If in a vehicle, be sure terminal on battery are clean and tight. c. Check AC outlet or extension cord connections. d. One or more cells may be shorted. Thermal switch in charger may cycle (click on and off). 4 3. ! Battery "eye" does not indicate a full charge even though charge complete indicator light is on. The battery is fully charged when the charge complete indicator light is on. Stratification of the electrolyte may prevent the battery eye from immediately indicating a full charge. Charging the battery for an additional hour with the charger SELECT FUNCTION switch set to START will in some instances restore the battery eye so it indicates a full charge. MAINTANENCE INSTRUCTIONS This charger requires minimal maintenance. As with any appliance or tool, a few common sense rules will prolong the life of the battery charger. ALWAYS BE SURE THE CHARGER IS UNPLUGGED BEFORE PERFORMING ANY MAINTENANCE OR CLEANING. 1. Store in a clean, dry place 2. Coil up the cords when not in use. 3. Clean the case and cords with a slightly damp cloth. 4. Clean any corrosion from the clamps with a solution of water and baking soda. 5. Examine the cords periodically for cracking or other damage and have them replaced if necessary. 6. WARNING: All other service should be done by qualified person...