Assessments - 3, GPA: 4.7
(
)
)
|
Facilidade de uso
•Do not apply shocks to the unit. •Do not subject the unit to direct sunlight. •Avoid using the unit in extremely hot or humid places. •Avoid using the unit in places subject to vibrations. A WORD ON THE EXCLUSIVE BATTERY PACKS The battery packs are nickel-cadmium batteries and nickel-metal hydride batteries. Give attention to the following to make the most of their characteristics. For charging: 10°C to 35°C (50°F - 95°F) For operating: 0°C to 40°C (32°F - 104°F) For storing: –10°C to 30°C (14°F to 86°F) EN-3 CHARGING THE BATTERY PACK CHARGING THE BATTERY PACK Marks CHG. (charge) indicator To AC outlet REFRESH switch REFRESH indicator REFRESH The AC power adapter features a REFRESH function that allows you to fully discharge the battery pack before recharging. Perform the REFRESH function after no less than 5 chargings. To discharge the battery . . . ...... attach the battery pack to the adapter as shown in the above illustration. Then push REFRESH. The REFRESH indicator lights when discharging starts, and goes out when discharging is complete. EN-4 SUPPLY POWER 1 1 Connect the charger’s AC power cord to a wall outlet. ATTACH BATTERY PACK 2 2 Align the marks and slide the battery pack in the direction of the arrow until it locks in place. •The CHG. indicator begins blinking to indicate charging has started. DETACH BATTERY PACK 3 3 When the CHG. indicator stops blinking but stays lit, charging is finished. Slide the battery pack opposite the direction of the arrow. BATT. PACK CHARGE DISCHARGE BN-V12U approx. 1 hr. 10 min. approx. 3 hrs. 30 min. BN-V22U approx. 2 hrs. 10 min. approx. 7 hrs. BN-V25U approx. 2 hrs. 40 min. approx. 10 hrs. NOTES:E . The recording time per charge is affected by such factors as the time spent in Record-Standby mode and the frequency of zooming. It is safer to have spare battery packs. . Charging times are for fully discharged battery pack, and discharging times are for fully charged battery pack. . Charging and discharging times vary according to the ambient temperature and the status of the battery pack. . Remember to set the charge marker after charging a battery pack or after detaching a discharged one from your camcorder. . High temperatures can damage the battery pack, so use only where good ventilation is available. Don’t allow it to discharge in container, such as a bag. . If you stop recharging or discharging part way through, make sure to remove the battery pack before unplugging the adapter’s AC cord. . Remove the battery pack from the adapter immediately after discharging. . To avoid interference with reception, do not use the AC Power Adapter/Charger near a radio. . Make sure you unplug the DC cord before charging or discharging the battery pack. . The CHG. indicator may not light properly with a brand new battery pack, or with one that’s been stored for an extended period. In this case, remove and reattach the battery pack and recharge it. The CHG. indicator should blink during recharging. If not, contact your nearest JVC dealer. . Perform the REFRESH function after no less than 5 chargings. . While the AC Power Adapter/Charger’s power cord is disconnected from the AC outlet, it is possible to discharge the battery by pressing the REFRESH switch. During that time, the AC Power Adapter/Charger does not charge the battery. When disharging is complete, detach the battery from the AC Power Adapter/ Charger to store it. EN-5 USING AC POWER USING AC POWER AC Power Adapter/ Charger AA-V15U To AC outlet DC OUT terminal Core Filter DC cord Use the AC Power Adapter (connect as shown in the illustration). NOTE:E The supplied AC Power Adapter/Charger features automatic voltage selection in the AC range from 110 V to 240 V. EN-6 INFORMATION SPECIFICATION INFORMATION SPECIFICATION This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Change or modifications not approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the rec...