Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
Safety Information
■ Read the operating instructions for the unit and all other com-
■ This manual uses pictographs to show you how to use the
ponents of your car audio system carefully before using the
product safely and to alert you to potential dangers resulting
Caution
❑ Do not install the product where it is exposed to
strong vibrations or is unstable.
system. They contain instructions about how to use the sys-
from improper connections and operations. The meanings of
tem in a safe and effective manner. Panasonic assumes no
the pictographs are explained below. It is important that you
Observe the following cautions when using this
Avoid slanted or strongly curved surfaces for installation. If
the installation is not stable, the unit may fall down while
responsibility for any problems resulting from failure to
fully understand the meanings of the pictographs in order to
unit.
driving and this can lead to an accident or injury.
observe the instructions given in this manual.
use this manual and the system properly.
❑ Keep the sound volume at an appropriate level.
❑ Installation Angle
Keep the volume level low enough to be aware of road and
The product should be installed in a horizontal position with
English
traffic conditions while driving.
the front end up at a convenient angle, but not more than
This pictograph intends to alert you to the pres-
This pictograph intends to alert you to the pres-
ence of important operating instructions and
ence of important operating instructions and
❑ Do not insert or allow your hand or fingers to be
30˚.
installation instructions. Failure to heed the
installation instructions. Failure to heed the
caught in the unit.
The user should bear in mind that in some areas there may
Warning
Caution
instructions may result in severe injury or death.
instructions may result in injury or material dam-
To prevent injury, do not get your hand or fingers caught in
be restrictions on how and where this unit must be installed.
age.
moving parts or in the disc slot. Especially watch out for
Consult your dealer for further details.
❑
infants.
Wear gloves for safety. Make sure that wiring is
❑
completed before installation.
This unit is designed for use exclusively in automo-
❑
biles.
To prevent damage to the unit, do not connect the
Warning
Observe the following warnings when
❑
power connector until the whole wiring is complet-
Do not operate the unit for a prolonged period with
installing.
ed.
the engine turned off.
Observe the following warnings when using
❑ Do not connect more than one speaker to one set of
❑ Disconnect the lead from the negative (–) battery
Operating the audio system for a long period of time with the
this unit.
speaker leads. (except for connecting to a tweeter)
terminal before installation.
engine turned off will drain the battery.
❑
❑ Do not expose the unit to direct sunlight or exces-
The driver should neither watch the display nor
Wiring and installation with the negative (–) battery terminal
sive heat.
Observe the following cautions when handling
operate the system while driving.
connected may cause electrical shock and injury due to a
Otherwise these will raise the interior temperature of the
the battery for the remote control unit.
Watching the display or operating the system will distract
short circuit.
unit, and it may lead to smoke, fire, or other damage to the
the driver from looking ahead of the vehicle and can cause
Some cars equipped with the electrical safety system have
● Use only specified battery (CR2025).
unit.
accidents. Always stop the vehicle in a safe location and use
specific procedures of battery terminal disconnection.
●
❑
Match the polarity of the battery with the (+) and (–) marks
the parking brake before watching the display or operating
FAILURE TO FOLLOW THE PROCEDURE MAY LEAD TO THE
Do not use the product where it is exposed to water,
in the battery case.
the system.
UNINTENDED ACTIVATION OF THE ELECTRICAL SAFETY
moisture, or dust.
● Replace dead battery as soon as possible.
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND
Safety Information
❑ Use the proper power supply.
Exposure of the unit to water, moisture, or dust may lead to
● Remove the battery from the remote control unit when not
PERSONAL INJURY OR DEATH.
smoke, fire, or other damage to the unit. Make especially
This product is designed for operation with a negative
using it for an extended period of time.
❑ Never use safety-related components for installa-
sure that the unit does not get wet in car washes or on rainy
grounded 12 V DC battery system. Never operate this prod-
● Insulate the battery (by placing them in a plastic bag or cov-
days.
uct with other battery systems, especially a 24 V DC battery
tion, grounding, and other such functions.
ering them with vinyl tape) before disposal or storage.
system.
Do not use safety-related vehicle components (fuel tank,
Observe the following cautions when
● Dispose of the battery according to the local regulations.
❑
brake, suspension, steering wheel, pedals, airbag, etc.) for
● Do not disassemble, recharge, heat or short the battery. Do
Keep batteries and insulation film out of reach of
installing.
wiring or fixing the product or its accessories.
not throw a battery into a fire or water.
infants.
❑ Installing the product on the air bag cover or in a
❑ Refer wiring and installation to qualified service
Batteries and insulation film can be ingested, so keep them
In case of battery leakage
personnel.
●
out of the reach of infants. If an infant ingests a battery or
location where it interferes with airbag operation is
Thoroughly wipe the battery liquid off the battery case and
Installation of this unit requires special skills and experience.
insulation film, please seek immediate medical attention.
prohibited.
insert new battery.
❑
For maximum safety, have it installed by your dealer.
● If any part of your body or clothing comes into contact with
Protect the Deck Mechanism.
❑ Check for piping, gasoline tank, electric wiring, and
Panasonic is not liable for any problems resulting from your
battery liquid, wash it with plenty of water.
Do not insert any foreign objects into the slot of this unit.
other items before installing the product.
own installation of the unit.
● If battery liquid comes into contact with your eyes, wash
❑ Do not disassemble or modify the unit.
If you need to open a hole in the vehicle chassis to attach or
wire the product, first check where the wire harness, gaso-
❑ Follow the instructions to install and wire the prod-
them with plenty of water and get immediate medical atten-
Do not disassemble, modify the unit or attempt to repair the
line tank, and electric wiring are located. Then open the hole
uct.
tion.
product yourself. If the product needs to be repaired, con-
from outside if possible.
Not following the instructions to properly install and wire the
sult your dealer or an authorized Panasonic Servicenter.
product could cause an accident or fire.
❑
❑
Do not use the unit when it is out of order.
Never install the product in a location where it inter-
❑ Take care not to damage the leads.
If the unit is out of order (no power, no sound) or in an
feres with your field of vision.
When wiring, take care not to damage the leads. Prevent
abnormal state (has foreign objects in it, is exposed to
❑ Never have the power cord branched to supply other
them from getting caught in the vehicle chassis, screws, and
water, is smoking, or smells), turn it off immediately and
equipment with power.
moving parts such as seat rails. Do not scratch, pull, bend or
consult your dealer.
❑ After installation and wiring, you should check the
twist the leads. Do not run them near heat sources or place
❑ The remote control unit should not lie about in the
normal operation of other electrical equipment.
heavy objects on them. If leads must be run over sharp
car.
The continuation of their using in abnormal conditions may
metal edges, protect the leads by winding them with vinyl
If the remote control unit lies about, it could fall on the floor
cause fire, electrical shock or a traffic accident.
tape or similar protection.
while driving, get wedged under the brake pedal, and lead to
❑ In the case of installation to an airbag-equipping
❑ Use the designated parts and tools for installation.
a traffic accident.
car, confirm warnings and cautions of the vehicle
Use the supplied or designated parts and appropriate tools
❑ Refer fuse replacement to qualified service person-
manufacturer before installation.
to install the product. The use of parts other than those sup-
nel.
❑ Make sure the leads do not interfere with driving or
plied or designated may result in internal damage to the unit.
When the fuse blows out, eliminate the cause and have it
getting in and out of the vehicle.
Faulty installation may lead to an accident, a malfunction or
replaced with the fuse prescribed for this unit by a qualified
❑ Insulate all exposed wires to prevent short circuit-
fire.
service engineer. Incorrect replacement of the fuse may lead
ing.
❑ Do not block the air vent or the cooling plate of the
to smoke, fire, and damage to the product.
unit.
Blocking these parts will cause the interior of the unit to
overheat and will result in fire or other damage.
2
CQ-C8401U/C8301U/C7401U/C7301U
CQ-C8401U/C8301U/C7401U/C7301U
3
... Este manual também é adequado para os modelos :
Unidade - CQC7401U (1.87 mb)
Unidade - CQC8301U (1.87 mb)
Unidade - CQC8401U (1.87 mb)