Assessments - 3, GPA: 3
(
)
)
|
Facilidade de uso
Do not install in locations where the entire support is at a diagonal such as in Figure B or where the monitor unit is facing down such as in Figure C. 2CAUTION Thoroughly wipe away and dust or grease from the installation location using a cloth which has been soaked in a neutral cleaning agent and wrung out. Attach the stand after allowing the installation location to dry. 1 Bend the stand support to conform to the shape of the installation location. 2 Adjust the shape of the support so that there is no rattling or gap when the stand is placed on the support. 3 Peel off the protective strip from the double-sided tape on the bottom of the stand and securely attach the stand. A B C 2CAUTION • Do not attach the double-sided tape more than once or touch the adhesive with your fingers as this will weaken its adhesive strength. • If the temperature of the surface of the installation location is low, warm it up using a heater or other means before attaching the stand. Low temperature may weaken the adhesive strength of the tape. • The supplied stand is specially intended for this product. Do not use it with another monitor. 4 Secure the stand using the supplied tapping screw (Accessory 3). 5 After attaching the stand, allow it to sit undisturbed for 24 hours. 6 Take care not to apply any force to the stand during this time. 7 Fully loosen the installation screws, align the slit on the rear of the unit with the installation shoe and slide the monitor unit onto the stand. 8 Adjust the height, horizontal angle and vertical angle of the monitor and securely tighten the installation screws. You can also adjust the monitor unit's forward position by loosening the angle adjustment knobs and adjusting the angle of the monitor unit's installation stand. English -5 Installation Installation for Monitor Unit Accessory 2 Accessory 3 (O4 x 12 mm) Protective strip Loosen Tighten Tighten Loosen Installation surface 6 - English Troubleshooting Guide What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. PROBLEM POSSIBLE CAUSE SOLUTION The power does not turn on. The fuse has blown. After checking for short circuits in the cables, replace the fuse with one having the same rating. No ACC position on vehicle Connect the same cable to the ignition. ignition as the battery cable. No video signal is input to the Input the video signal. Video input terminal. The screen is dark. The unit is in a location where If the temperature of the monitor temperature is low. unit drops, the screen may appear darker when power is first turned on due to the characteristics of a liquid crystal panel. Wait a while after turning power on for the temperature to rise. Normal brightness will return. Specifications Specifications subject to change without notice. Monitor Unit Screen size ..............................................................................................6.4 inches (Normal) 130.8(W) x 98(H) x 162.5(Diagonal) mm Display system..............................................................................Transparent TN LCD panel Drive system ..................................................................................TFT active matrix system Number of pixels ........................................................224,640 pixels (320 H x 234 V xRGB) Effective pixels ..........................................................................................................99.99% Pixel arrangement ..........................................................................RGB striped arrangement Back lighting ..............................................................................................Cold cathode tube Color System..........................................................................................................NTSC/PAL Video Input Level................................................................................................1 Vp-p/ 75 . General Operating voltage ..............................................................................14.4 V DC (11 to 16 V) Consumed Power ..........................................................9 W (6 W during normal operations) Operational temperature range......................................................................–10°C to +60°C Storage temperature range............................................................................–30°C to +85°C Size ..........................................................................................188(W) x 130(H) x 31(D) mm Mass ............................................................................................................................460 g Although the effective pixels for the liquid crystal panel is given as 99.99% or more, 0.01% of pixels may not light or may light incorrectly. English -7 Precautions de securite 2AVERTISSEMENT Pour eviter toute blessure et/ou incen...