Assessments - 4, GPA: 4.8
(
)
)
|
Facilidade de uso
Do not immerse kettle, power base, power cord and plug into water or other liquid. ■ Do not use the appliance if it damaged or malfunctioned in any manner. Return to the Customer Service for examination and repair. ■ If the power cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Do not operate the appliance with a severed or damaged cord or plug. ■ Unplug the appliance when not in use and before cleaning or in the event to a fault. ■ The appliance is hot when in use. To avoid burns or scalds, do not let bare skin touch hot surfaces. Always hold handle while moving, filling or lifting the appliance. Pouring water slowly and carefully. ■ Keep the appliance out of reach of the children. Close attention is necessary when the appliance is used near children. ■ Do not put or place the appliance or cable on hot surface, stove or toaster. ■ Do not place the appliance on a metal surface or tray. —Q~ ■ Do not let cable hang over edge of table, or run across an open space. ■ Do not pull the cable across sharp edge or use the cable to carry the appliance. ■ Do not locate the appliance near the sink or edge of table counter where appliance may have the risk to fall down causing hazardous. ■ Boil as much water as you need. ■ Always fill enough water to cover the bottom of the kettle. ■ Do not fill an empty kettle whilst it is still hot as this may cause scalding. ■ Close the lid securely before switch on the appliance and do not open the lid while boiling as it will interrupt the auto switch off and cause scalding by steam. ■ Appliance should be used on a firm, flat and level surface. ■ Do not fill the kettle over the Max. level as boiling water will be spited out the spout and around the lid causing scalding. Use the appliance to boil water only and never use to boil other liquid such milk, coffee or soup. ■ Empty the appliance after use. And do not switch on while the appliance is empty as the stainless steel bottom may be damaged or became discoloration. ■ Cold down and empty the appliance before removal the filter. ■ Use the appliance only on the power base unit provided. Do not fill water when appliance stand on the power base unit. ■ Do not use the appliance outdoors. ■WARNING: THIS APPLIANCE MUST BE EARTHED. SAVE THESE INSTRUCTION 3 1114.qxd 17.03.03 17:16 Page 8 e FITTING WITH A 3-PINS PLUG Important: The wires in the mains lead are colored in accordance with the following code: Green/Yellow = Earth If the colors of the wires in the mains cord do not correspond with the markings identifying the terminal on the plug, proceed as follows: The wire, which is colored green & yellow, must be connected to the terminal in the plug that is marked with the letter 'E' or the earth symbol' \' or colored green or green & yellow. The wire, which is colored blue, must be connected to the terminal that is marked with the letter 'N' or colored black. The wire, which is colored brown, must be connected to the terminal that is marked with the letter 'L' or colored red. INSTRUCTION FOR USE OF THIS APPLIANCE ■ Before using for the first time, boil the kettle twice with clear water to make sure that it is completely clean. Pour away all the boiled water and refill. ■ Kettle can be filled either through the spout or open the lid. Then fill water. ■ Water level can be estimated through the window gauges at both sides on body. ■ After filling your kettle with water, place the kettle to the power base unit, ensure the kettle completely sits on the connector. Plug in and switch on the wall socket. Switch on the kettle by pressing down the switch button. ■ Do not overfill the kettle over the Max. level. However the minimum amount of water should reach the Min. marking. ■ When the water boils, kettle will be automatically switch off. ■ To re-boil the water, switch on again by just pressing down the switch button once again. If the kettle has just switch off automatically, waiting for a minute before switching it. ■ If the kettle do not fill with enough water or it is empty; switch on the kettle will cause the safety cutout switch off the power automatically. If this happens, set the switch level to OFF position and wait for a few minutes for the appliance to cool down, then refill with enough water and switch on as normal. ■ Before removes the kettle from power stand, ensure that the kettle is switched ■ Power cord could be stand into the power base by just push the cord inside the base. FILTER ■ If appliance in...