Assessments - 4, GPA: 3.5
(
)
)
|
Facilidade de uso
Refer all servicing to qualified service personnel. Replacement Parts – When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or having the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. Safety Check – Upon the completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition. Condensation – Moisture may form on the CD pickup lens when: -The unit is moved from a cold spot to a warm spot -The heating system has just been turned on -The unit is used in a very humid room -The unit is cooled by an air conditioner When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again. ENGLISH 3 Power supply OPE/BATT The OPE/BATT indicator lights up while the power is on. Using on AC house current Connect the AC cord as illustrated below. 1 to the AC inlet of the unit supplied AC cord 2 to an AC outlet (AC 120 V, 60 Hz) • The rated voltage of the unit is 120 V AC. • If abnormal high voltage is supplied, “Hi” flashes in the display and the unit does not accept any operation. Disconnect the AC cord. CAUTION Use only the supplied AC cord. Use with other cords may result in the risk of fire. Using on batteries Open the lid of the battery compartment on the rear and insert eight R14 (size C) batteries, not supplied, as illustrated below. Then close the lid. To switch from AC power supply to battery supply, disconnect the AC cord from the AC inlet. R14 (C) When the OPE/BATT indicator becomes dim, volume decreases, or sound is distorted during operation, replace the batteries. When the batteries become weak during tape operation, “Lo” flashes in the display. In stop mode, the unit will not accept REC, ePLAY/PAUSE, fand g. In playback or recording mode, the unit will be stopped and turned off. Replace the batteries. Notes on batteries To avoid damage from leakage or explosion, observe the following: • Insert the batteries with the 0and 9marks correctly aligned. • Do not mix different types of batteries or old batteries with new ones. • When the unit is not to be used for a long period, remove the batteries. • Never recharge the batteries, apply heat to them or take them apart. • Remove dead batteries. If liquid leaks from the batteries, wipe thoroughly to remove. Maintenance To clean the cabinet Use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner. To clean the heads When the tape heads are dirty; -high frequency sound is not emitted -the sound is not adequately high -the sound is off-balance -the tape cannot be erased -the tape cannot be recorded on After every 10 hours of use, clean the tape heads with a head cleaning cassette. Use separately sold dry-type or wet-type cleaning cassette. Refer to the instructions of the cleaning cassette for details. To clean the lens Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge. Lens 4 ENGLISH Remote control (CSD-TD59 only) Insert two R6 (size AA) batteries. R6 (AA) When the reach of the remote control signal is less than 5 meters (16 feet), replace the batteries. The remote control may not operate correctly when: -The unit is exposed to intense light, such as direct sunlight -Objects block the remote control signal to the unit To use the buttons on the remote control Buttons on the remote control and the main unit with identical indications have the same functions. To turn the power on Press POWER to turn on the display. When using the unit on the batteries, this button will not turn the power on. To turn the power off Press POWER to turn off the display. To use the FUNCTION button Each time FUNCTION is pressed while the power is on, the function is selected cyclically. CD TAPE RADIO FUNCTION POWER Specifications Radio section Frequency range, antenna – FM: 87.5 - 108.0 MHz Rod antenna, AM: 530/531 - 1,710/1,602 kHz (10/9 kHz step) Ferrite bar antenna Deck section Track format – 4 tracks, 2 channels / Frequency range – Normal tape: 50 - 12,500 Hz (JEITA) / Recording system – AC bias / Erasing system – AC erase / Heads – Recording/playback head (1), Erasure head (1) CD player section Disc – Compact disc / Scanning method – Non-contact optical scanner (semiconductor laser) / Laser diode properties – Material: GaAlAs Wavelength: . = 780 nm Emission duration: Continuous Laser output: Less than 44.6 .W (This output is the value measured at a distance of 200 mm from the objective lens surface on the optical pick-up block with 7 mm aperture.) General Speaker – 80 mm cone type (2) / Output – Headphones jack (stereo mini-jack) / Power output – 2.5 W + 2.5 W (JEITA, 7 ohms, THD 10% DC) / Power requirements – DC 12 V using eight size C (R14) batteries, AC...
Este manual também é adequado para os modelos :Ditado - CSD-TD59 (876.65 kb)