Assessments - 4, GPA: 3.5
(
)
)
|
Facilidade de uso
11. Wash the drum(s), hopper drip tray(s), top cover(s), and outer enclosure using a clean wash cloth that has been dampened in the hot water and sanitizer solution. Pay particular attention to the shaft area and make sure it is thoroughly cleaned and sanitized. 12. Thoroughly rinse all surfaces with a clean wash cloth that has been dampened with hot water. Wipe dry with a clean dry wash cloth before reassembling the dispenser. NOTE – Although most parts are dishwasher safe, they may be affected by the chemicals in some commercial sanitizing agents. Do not place the hopper nor hopper lids in a dishwasher. Rinse thoroughly before assembly. 9. Remove the drip tray and cover. 43553 071410 3 ASSEMBLY 4. Install the hopper over the auger and cooling drum and slide it into place. Push down until the hopper lock plunger snaps into place. 1. Replace the auger nose bushing inside the front of the hopper. 3. Align the auger shafts with the augers. Push the augers as far as they will go and rotate them so the flat face of the auger shaft is aligned with the flat face of the auger nose. 2. Install the hopper seal over the flange at the rear of the cooling drum as shown. 6. Slide the faucet valve assembly into place on the hopper. 5. Position the faucet seal and the return spring in the faucet valve. 7. Press down on the valve to compress the spring. Position the faucet handle over the faucet valve one side at a time and snap into place on the hopper. 8. Install the drip tray and cover. 11. Reassemble and install all PAF parts. Return power switch to the ON position. Close Door. 10. Slide PAF assembly forward. NOTE: Whether liquid concentrate or granulated powder, all product must be thoroughly mixed BEFORE adding it to the hoppers. 9. Turn ON augers and cooling function to desired settings. 43553 071410 THOROUGH CLEANING OF THE PAF HOPPER (Once a week) 4. Remove the Wiper Blade and Drive Gear by removing the Retaining Ring from the Wiper Blade Shaft. Remove Auger by pulling it out the front of Hopper Base. 3. Pull the Ejector Elbow off the Hopper Base. Remove the Slide Gate from the Ejector Elbow. 2. Slide the gate shut on the powder hopper and remove the hopper. Remove the Cover and empty the contents. 1. Open the Cabinet Door and allow the support arms to lock in place. 6. Wash all components in a mild solution of dish detergent using a bristle brush when needed. Rinse and dry each item thoroughly before reassembling. NOTE: Parts must be thoroughly dry before adding powder to the hopper. 5. Remove the Auger Drive Shaft by turning the screw of the Auger Drive Bracket in a clockwise direction. 43553 071410 ...
Este manual também é adequado para os modelos :Dispensadores - ULTRA-2 PAF (2.59 mb)