Assessments - , GPA: ( )

Instruções de Operação Milwaukee, Modelo 9072-22

Fabricante : Milwaukee
Arquivo Tamanho: 416.12 kb
Arquivo Nome :

Língua de Ensino:

O documento está colocado, por favor, espere

Baixe o seu Fechar

O documento está colocado, por favor, espere

Baixe o seu Fechar

Fig. 6 Forward Reverse Forward/ Reverse Switch 1. For forward (clockwise) rotation, push the forward/reverse switch in the direction shown. Check the direction of rotation before use. 2. For reverse (counterclockwise) rotation, push the forward/reverse switch in the direction shown. Check the direction of rotation before use. WARNING To reduce the risk of injury, keep hands and cord away from the bit and all moving parts. WARNING To reduce the risk of explosion, electric shock and property damage, always check the work area for hidden pipes and wires before drilling. Fig. 7 WARNING To reduce the risk of injury, only grasp tool by handle and red insulated surfaces (Fig. 7). Do not hold gray gear case when impacting or drilling. Starting, Stopping and Controlling Speed (Fig. 8) Cat. No. 9072-20, 9072-22, 9092-20, and 9096-20 Fig. 8 Trigger Speed dial To increase the speed This impact wrench may be operated at any speed from 0 to full speed. The speed will remain variable up to the chosen speed dial setting by use of the trigger. The speed dial turns clockwise to increase the speed or counterclockwise to decrease the speed (Fig. 8). 1. Select a speed on the speed dial. 2. To start the tool, pull the trigger. 3. To vary the driving speed, increase or decrease pressure on the trigger. The further the trigger is pulled, the greater the speed. 4. To stop the tool, release the trigger. Starting and Stopping the Tool (Fig. 9) Cat No. 9070-20, 9071-20, 9075-20 These impact wrenches are equipped with a rocker switch that offers both forward and reverse rotation. Rocker switch Fig. 9 1. For forward (clockwise) rotation, pull the lower portion of the switch. 2. For reverse (counterclockwise) rotation, pull the upper portion of the switch. NOTE: To prevent damage to the motor and internal mechanism, allow the motor to stop completely before switching from forward to reverse or from reverse to forward. Impacting Techniques The longer a bolt, screw, or nut is impacted, the tighter it will become. To help prevent damaging the fasteners or workpieces, avoid excessive impacting. Be particularly careful when impacting smaller fasteners because they require less impacting to reach optimum torque. Practice with various fasteners, noting the length of time required to reach the desired torque. Check the tightness with a hand-torque wrench. If the fasteners are too tight, reduce the impacting time. If they are not tight enough, increase the impacting time. Impacting for two seconds is generally sufficient for a 3/8" bolt and one second for a 5/16" bolt. However, oil, dirt, rust or other matter on the threads or under the head of the fastener affects the degree of tightness. The torque required to loosen a fastener averages 75% to 80% of the tightening torque, depending on the condition of the contacting surfaces. However, if rust or corrosion causes seizing, more torque may be required. On light gasket jobs, run each fastener down to a relatively light torque and use a hand torque wrench for fi nal tightening. page 6 MAINTENANCE WARNING To reduce the risk of injury, always unplug your tool before performing any maintenance. Never disassemble the tool or try to do any rewiring on the tool's electrical system. Contact a MILWAUKEE service facility for ALL repairs. MAINTENANCE WARNING To reduce the risk of injury, always unplug your tool before performing any maintenance. Never disassemble the tool or try to do any rewiring on the tool's electrical system. Contact a MILWAUKEE service facility for ALL repairs. Maintaining Tools Keep your tool in good repair by adopting a reg...