Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
2 Insert the video light into the convex screw, and screw the video light. Adjusting the angle of the video light (Illustration E) 1 Unfasten the lighting angle adjusting screw with a coin and adjust the angle of the video light. 2 Fasten the lighting angle adjusting screw with a coin and lock firmly to fix the angle of the video light. Note When adjusting the angle, hold the video light body firmly while loosening the lighting angle adjusting screw. (Continued on the reverse side.) The time before the batteries run out varies depending on the frequency of use of the batteries and the ambient temperature. This indicator should only be used as a rough guide, and it is recommended that the batteries be replaced promptly. • When the battery pack runs out When the battery pack runs out, the video light goes out and the remaining battery lamp turns green and blinks rapidly for about 10 seconds (1 segment). Set the POWER switch to OFF and recharge the battery pack or replace it with a fully charged battery pack. • Communication error (4 segments flash) For about 10 seconds after the remaining battery check is complete If an error occurs for some reason during communication with the battery pack or if batteries other than the Sony “InfoLITHIUM” battery pack L series are inserted, 4 segments flash for 10 seconds to indicate a communication error and then the remaining battery display disappears. Notes • When using batteries other than the Sony “InfoLITHIUM” battery pack L series (NP-F900 range, NP-F700 range) with the video light, the remaining battery capacity will not be displayed. •When using a battery pack that only has a short lifetime remaining, the remaining battery display may not agree with the actual remaining battery capacity. • When using a “InfoLITHIUM” battery pack attached to the “InfoLITHIUM” compatible AC adaptor/charger, the available operating time will not be displayed. To display the operating time, attach the battery pack to the camcorder and then use for about 20 seconds before attaching the battery pack to the AC adaptor/charger again. • The battery pack cannot be recharged with the video light. TEMP lamp When the white LED overheats for some reason, the video light will be turned off for safety reasons, and the TEMP lamp turns red and blinks rapidly for about 60 seconds. If the ambient temperature is high, use the video light at a lower temperature. If the TEMP lamp continues to blink, stop using the video light and consult your Sony dealer or local authorized Sony service facility. Removing the video light 1 Set the POWER switch to OFF. 2 Slide the battery release button and at the same time pull the battery pack upward. 3 Turn the light attachment knob on the video light toward RELEASE. If the video light is attached to a convex screw, loosen...